Wiki source code of DMX Input via Pharos

Last modified by Scott Kohlmann on 2023/04/20 21:24

version	line-number	content
8.1	1	(% class="box warningmessage" %)
	2	(((
9.1	3	Note: This should only be used if there is no ability to generate an e-DMX (sACN/Art-Net) feed into ShowRunnerCLC™. [[E-DMX receiver>>doc:SHOWRUNNER™ Integrations Guide.Integration Options.sACN and ArtNet Receive.WebHome]] is much more efficient.
8.1	4	)))
2.1	5
9.1	6	ShowRunnerCLC™ can accept commands from a Pharos' DMX input. Note: Pharos recommends not using more than 50 channels on the DMX input. Use as few channels as possible and try not to send fades over DMX into the Pharos.
8.1	7
2.1	8	Steps:
	9
9.1	10	ShowRunnerCLC™
2.1	11
9.1	12	1. Enable [[UDP Listener>>doc:SHOWRUNNER™ Integrations Guide.Integration Options.UDP Input.WebHome]] in the ShowRunnerCLC™ config:
2.1	13
	14	"UdpListener":
	15	{
	16	"ListenPort": 45794
	17	},
	18
	19	Pharos Config:
	20
	21	1. Create a new Pharos Project or Open an Existing One
	22	1. Go to Project->Project Features and set DMX In under Trigger to Enabled
	23	1. Go to Network->Select Controller with DMX Input->Interfaces and set the Serial Port to DMX Input
	24	1. Triggers
9.1	25	11. Create a trigger on each DMX Input that you wish to send to ShowRunnerCLC™
2.1	26	11. Set Trigger Parameters:
	27	111. Channel: Channel # you wish to capture
	28	111. Changes in range: Minimum: 0 Maximum: 255
	29	11. New Action: Output Ethernet
	30	111. Enable Variables
9.1	31	111. IP/Hostname: IP Address or Hostname of the processor running ShowRunnerCLC™
2.1	32	111. Port: 45794
	33	111. Protocol: UDP
	34	111. String: "GID.SetLevelByByte.<3>\r"
9.1	35	1111. GID is the GlobalID for the load within ShowRunnerCLC™
2.1	36	111. Example DMX Channel 41 controlling load with global ID of 32:
	37	[[image:1597260805025-107.png\|\|height="58" width="693"]]
	38
	39

Wiki source code of DMX Input via Pharos

Navigation