Wiki source code of DMX Input via Pharos

Last modified by Alexander Mott on 2024/06/14 18:25

author	version	line-number	content
		1	(% class="box warningmessage" %)
		2	(((
		3	Note: This should only be used if there is no ability to generate an e-DMX (sACN/Art-Net) feed into ShowRunnerCLC™. [[E-DMX receiver>>doc:SHOWRUNNER™ Integrations Guide.Integration Options.sACN and ArtNet Receive.WebHome]] is much more efficient.
		4	)))
		5
		6	ShowRunnerCLC™ can accept commands from a Pharos' DMX input. Note: Pharos recommends not using more than 50 channels on the DMX input. Use as few channels as possible and try not to send fades over DMX into the Pharos.
		7
		8	Steps:
		9
		10	ShowRunnerCLC™
		11
		12	1. Enable [[UDP Listener>>doc:SHOWRUNNER™ Integrations Guide.Integration Options.UDP Input.WebHome]] in the ShowRunnerCLC™ config:
		13
		14	(% class="box" %)
		15	(((
		16	## "UdpListener":
		17	{
		18	"ListenPort": 45794
		19	},##
		20	)))
		21
		22	Pharos Config:
		23
		24	1. Create a new Pharos Project or Open an Existing One
		25	1. Go to Project->Project Features and set DMX In under Trigger to Enabled
		26	1. Go to Network->Select Controller with DMX Input->Interfaces and set the Serial Port to DMX Input
		27	1. Triggers
		28	11. Create a trigger on each DMX Input that you wish to send to ShowRunnerCLC™
		29	11. Set Trigger Parameters:
		30	111. Channel: Channel # you wish to capture
		31	111. Changes in range: Minimum: 0 Maximum: 255
		32	11. New Action: Output Ethernet
		33	111. Enable Variables
		34	111. IP/Hostname: IP Address or Hostname of the processor running ShowRunnerCLC™
		35	111. Port: 45794
		36	111. Protocol: UDP
		37	111. String: "GID.SetLevelByByte.<3>\r"
		38	1111. GID is the GlobalID for the load within ShowRunnerCLC™
		39	111. Example DMX Channel 41 controlling load with global ID of 32:
		40	[[image:1597260805025-107.png\|\|height="58" width="693"]]
		41
		42