Changes for page DMX Input via Pharos

Last modified by Alexander Mott on 2024/06/14 18:25
From version 1.1
edited by Mark Kohlmann
on 2020/08/12 19:33
Change comment: Uploaded new attachment "1597260805025-107.png", version {1}
To version 9.1
edited by Scott Kohlmann
on 2023/04/20 21:24
Change comment: There is no comment for this version

Summary

Details

Page properties
Title
... ... @@ -1,0 +1,1 @@
1 +DMX Input via Pharos
Parent
... ... @@ -1,0 +1,1 @@
1 +SHOWRUNNER™ Integrations Guide.Integration Options.WebHome
Author
... ... @@ -1,1 +1,1 @@
1 -XWiki.mark\.kohlmann@chiefintegrations\.com
1 +XWiki.scott\.kohlmann@chiefintegrations\.com
Content
... ... @@ -1,0 +1,39 @@
1 +(% class="box warningmessage" %)
2 +(((
3 +Note: This should only be used if there is no ability to generate an e-DMX (sACN/Art-Net) feed into ShowRunnerCLC™.  [[E-DMX receiver>>doc:SHOWRUNNER™ Integrations Guide.Integration Options.sACN and ArtNet Receive.WebHome]] is much more efficient.
4 +)))
5 +
6 +ShowRunnerCLC™ can accept commands from a Pharos' DMX input.  Note: Pharos recommends not using more than 50 channels on the DMX input.  Use as few channels as possible and try not to send fades over DMX into the Pharos.
7 +
8 +Steps:
9 +
10 +ShowRunnerCLC™
11 +
12 +1. Enable [[UDP Listener>>doc:SHOWRUNNER™ Integrations Guide.Integration Options.UDP Input.WebHome]] in the ShowRunnerCLC™ config:
13 +
14 + "UdpListener":
15 + {
16 + "ListenPort": 45794
17 + },
18 +
19 +Pharos Config:
20 +
21 +1. Create a new Pharos Project or Open an Existing One
22 +1. Go to Project->Project Features and set DMX In under Trigger to Enabled
23 +1. Go to Network->Select Controller with DMX Input->Interfaces and set the Serial Port to DMX Input
24 +1. Triggers
25 +11. Create a trigger on each DMX Input that you wish to send to ShowRunnerCLC™
26 +11. Set Trigger Parameters:
27 +111. Channel: Channel # you wish to capture
28 +111. Changes in range: Minimum: 0 Maximum: 255
29 +11. New Action: Output Ethernet
30 +111. Enable Variables
31 +111. IP/Hostname: IP Address or Hostname of the processor running ShowRunnerCLC™
32 +111. Port: 45794
33 +111. Protocol: UDP
34 +111. String: "GID.SetLevelByByte.<3>\r"
35 +1111. GID is the GlobalID for the load within ShowRunnerCLC™
36 +111. Example DMX Channel 41 controlling load with global ID of 32:
37 +[[image:1597260805025-107.png||height="58" width="693"]]
38 +
39 +