Changes for page Zūm Net Device Setup

Last modified by Alexander Mott on 2024/10/22 19:55
From version 8.1
edited by Alexander Mott
on 2022/06/16 20:24
Change comment: Uploaded new attachment "1655411066727-374.png", version {1}
To version 9.1
edited by Alexander Mott
on 2022/06/16 20:40
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -69,12 +69,39 @@
69 69  
70 70  === Zūm Net Specific Configuration ===
71 71  
72 -Zūm Net devices have
72 +Zūm Net devices have a two additional settings not present for other devices: Zūm/Cresnet mode and Master/Slave mode.
73 73  
74 -App vs Cresnet mode
74 +==== Zūm/Cresnet Mode ====
75 75  
76 -Master vs Slave
76 +ZUMNET-JBOXs should ship in "Zūm Mode" by default, also known as "App Mode" because this is the setting required to be able to configure Zūm Wired rooms using the Crestron Zūm Mobile App.
77 77  
78 +If a ZUMNET-JBOX is put into Cresnet mode, it will no longer be able to be configured using the App and all internal logic will be disabled. Generally, Cresnet mode is only required if non Zūm Link devices are connected to the ZUMNET-JBOX (e.g. a GL-EXP-DIMU-CN phase dimmer or C2N-CBD-P Cameo keypads).
79 +
80 +The commands to view or change the Zūm/Cresnet mode are:
81 +
82 +* View current mode: ##zwmode##
83 +* Make Zūm/App mode: ##zwmode zum##
84 +* Make Cresnet mode: ##zwmode cnet##
85 +
86 +A reboot is required if the mode is to be changed. Note that this command will also display the current Master/Slave mode, but will not allow you to change it.
87 +
88 +==== Master/Slave Mode ====
89 +
90 +ZUMNET-JBOXs should ship in "Master" mode by default, and generally this is how they should be configured.
91 +
92 +"Slave" mode effectively turns a ZUMNET-JBOX into a ZUMLINK-JBOX. There are two scenarios in which a ZUMNET-JBOX will need to be configured in "Slave" mode:
93 +
94 +1. It is connected to another ZUMNET-JBOX via the Zūm Link bus
95 +1. It is being used as a Cresnet device, connected to a processor or DIN-CENCN-2 using a Cresnet/Zūm Link adapter
96 +
97 +The commands to view or change the Master/Slave mode are:
98 +
99 +* View current mode: ##zwms##
100 +* Make "master": ##zwms master##
101 +* Make "slave": ##zwms slave##
102 +
103 +A reboot is required if the mode is to be changed.
104 +
78 78  === Changing IP-IDs ===
79 79  
80 80  If ZUMNET-JBOXs must be assigned different IP-IDs than indicated in the SRTakeoff.xlsx, or if Zūm Link devices are moved between ZUMNET-JBOXs, then the configuration file must be updated. Every Zūm Link device in the configuration has a ##"DeviceHostId"## associated with it, which corresponds to the IP-ID of the ZUMNET-JBOX hosting it.