Skip to Content

Changes for page Zūm Net Device Setup

Last modified by Alexander Mott on 2025/07/10 21:27
From version 54.1
edited by Alexander Mott
on 2025/07/10 21:22
Change comment: There is no comment for this version
To version 55.1
edited by Alexander Mott
on 2025/07/10 21:25
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -185,9 +185,9 @@
185 185  
186 186  == Zūm/Cresnet Mode ==
187 187  
188 -{{warning}}
188 +{{error}}
189 189  ZUMNET-JBOXs on firmware 4.x.x and above that exceed the maximum allowable ZUMLINK device count must be kept in CNET mode and not be allowed into Zūm Mode.
190 -{{/warning}}
190 +{{/error}}
191 191  
192 192  Zūm Mode (also known as App Mode) is the default setting for ZUMNET-JBOXs shipping on newer firmware, and allows them to be configured from the Crestron Zūm App as long as a ZUMLINK-KP is connected to the JBOX. If a ZUMNET-JBOX is put into Cresnet mode, it will no longer be able to be configured using the Crestron Zūm App and all internal logic will be disabled.
193 193  
... ... @@ -229,6 +229,7 @@
229 229  {{error}}
230 230  ZUMNET-JBOXs on firmware 4.x.x and above that exceed the maximum allowable ZUMLINK device count must not have Auto Switch enabled. Doing so will result in unintended behavior, including improper app mode functionality and excessive rebooting once reconnected to the processor.
231 231  {{/error}}
232 +
232 232  {{warning}}
233 233  With Auto Switch enabled, ZUMNET-JBOXs may overwrite the ShowRunnerCLC™ scenes upon reconnecting to the processor: disable auto switch or set scenes both in the App and in ShowRunnerCLC™ to avoid this issue
234 234  {{/warning}}