Changes for page Zūm Net Device Setup

Last modified by Alexander Mott on 2024/10/22 19:55
From version 46.1
edited by Alexander Mott
on 2023/10/10 16:31
Change comment: There is no comment for this version
To version 45.1
edited by Alexander Mott
on 2023/10/06 22:52
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -178,8 +178,6 @@
178 178  
179 179  Zūm Mode Auto Switch is a feature introduced by Crestron in November of 2022 with .puf firmware v1.04.05 (device firmware 1.004.00005). This feature is intended to address concerns that arose from projects using custom programs with ZUMNET-JBOX-* devices in CNET Mode. Previously, if a device in CNET Mode lost connection to the processor, then it would be impossible to maintain any sort of control over the lighting. With Zūm Mode Auto Switch enabled, a ZUMNET-JBOX running in CNET Mode will automatically switch to App Mode and process local logic in the event that it loses connection to the processor.
180 180  
181 -Note that on 0-10V and switched JBOXs, the connected loads will flash once when rebooting. On ZUMNET-DALI-JBOX models, the JBOX will reboot once when switching to App mode and twice when switching back to CNET mode (once to switch to CNET, and a second time to switch to Legacy DALI mode)
182 -
183 183  Enable Zūm Mode Auto Switch using the command: ##autoswitch on##
184 184  
185 185  Rebooting after changing Auto Switch modes is not officially required, but is still recommended.