Changes for page Zūm Net Device Setup

Last modified by Alexander Mott on 2024/10/22 19:55
From version 43.1
edited by Alexander Mott
on 2023/05/16 14:29
Change comment: There is no comment for this version
To version 42.1
edited by Alexander Mott
on 2023/05/16 14:22
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -140,8 +140,8 @@
140 140  
141 141  (% class="box warningmessage" %)
142 142  (((
143 -Zūm Wired firmware v1.03.27 (device firmware v1.002.00026) updates the terminology from "master"/"slave" to "primary"/"secondary", and changes the ##zwms## command to ##zwps##
144 -Devices running this newer firmware will not accept commands using "master"/"slave" as arguments.
143 +Zūm Wired firmware v1.03.27 (device firmware v1.002.00026) updates the terminology from "master"/"slave" to "primary"/"secondary", and adds the ##zwps## command in addition to the previous ##zwms## command.
144 +Devices running this newer firmware will not accept commands using "master"/"slave" as arguments, but will still accept either ##zwms## or ##zwps## as the command.
145 145  )))
146 146  
147 147  ZUMNET-JBOXs can be in either "Primary" or "Secondary" mode. In most situations, "Primary" is the desired mode of operations, as "Secondary" mode effectively turns a ZUMNET-JBOX into a ZUMLINK-JBOX and prevents it from discovering devices on the Zūm Link bus or performing any logic. There are two scenarios in which a ZUMNET-JBOX should be configured in "Secondary" mode: