Changes for page Zūm Net Device Setup
                  Last modified by Alexander Mott on 2025/07/10 21:27
              
      
      From version  1.1 
    
    
              edited by Alexander Mott
        
on 2022/06/13 21:56
     on 2022/06/13 21:56
      Change comment:
              There is no comment for this version
          
         
      To version  3.1 
    
    
              edited by Alexander Mott
        
on 2022/06/14 22:50
     on 2022/06/14 22:50
      Change comment:
              Uploaded new attachment "1655247008527-737.png", version {1}
          
         Summary
- 
          Page properties (1 modified, 0 added, 0 removed)
 - 
          Attachments (0 modified, 2 added, 0 removed)
 
Details
- Page properties
 - 
      
- Content
 -   
... ... @@ -1,6 +1,6 @@ 1 1 === ZUMNET-JBOXs in SHOWRUNNER™ === 2 2 3 -ZUMNET-JBOXs are part of Crestron's latest Zūm Wired system, acting as an Ethernet-to-Zūm Link bridge to convert between Ethernet and Zūm Link data traffic. This helps avoid issues with bandwidth over the Cresnet bus for jobs which have a large number of Cresnet devices, as well as allowing for additional power supplies to provide power Cresnet devices.3 +ZUMNET-JBOXs are part of Crestron's latest Zūm Wired system, acting as an Ethernet-to-Zūm Link bridge to convert between Ethernet and Zūm Link data traffic. 4 4 5 5 For SHOWRUNNER™ installations, the IP address of the DIN-CENCN-2 does not matter as long as it is in the same range as the processor and does not conflict with any other devices on the network. Instead, DIN-CENCN-2s are identified to the processor via their IP-ID. Note that which Cresnet devices are landed at each Net of each DIN-CENCN-2 matters, and if devices are moved between Nets or between DIN-CENCN-2s then the configuration will need to be updated (see below). Chief Integrations typically provides an SRTakeoff.xlsx spreadsheet with an IP Table tab that lists all the DIN-CENCN-2 IP-IDs in the program. If no takeoff is provided, then the processor's IP table can be checked by running the ##ipt -t ##command from the processor after the configuration is loaded. DIN-CENCN-2's will typically have IP-IDs in the "##Dx##" range. 6 6  
 
- 1655246948921-246.png
 -   
- Author
 -   
... ... @@ -1,0 +1,1 @@ 1 +XWiki.alexander\.mott@chiefintegrations\.com  - Size
 -   
... ... @@ -1,0 +1,1 @@ 1 +10.6 KB  - Content
 
 - 1655247008527-737.png
 -   
- Author
 -   
... ... @@ -1,0 +1,1 @@ 1 +XWiki.alexander\.mott@chiefintegrations\.com  - Size
 -   
... ... @@ -1,0 +1,1 @@ 1 +41.8 KB  - Content