Skip to Content
Last modified by Alexander Mott on 2024/06/13 19:47
From version 4.1
edited by Alexander Mott
on 2024/06/13 19:39
Change comment: There is no comment for this version
To version 5.1
edited by Alexander Mott
on 2024/06/13 19:41
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -5,8 +5,7 @@
5 5  These are the hardware/networking requirements for integrating a third-party DMX controller with ShowRunnerCLC™'s eDMX receiver:
6 6  
7 7  * Third-party controller must be capable of sending eDMX commands via sACN or Art-Net
8 -* Third-party controller must be able to send eDMX signals to the lighting control processor
9 -** i.e. third-party controller must be on the same LAN or VLAN as the lighting control processor
8 +* Third-party controller must be able to send eDMX signals to the lighting control processor (i.e. third-party controller must be on the same LAN or VLAN as the lighting control processor, or the building LAN must be configured in such a way as to allow this communication)
10 10  * If either of the above cannot be achieved, then a [[DIN-SACN-DMX (Enttec DIN Ethergate 2)>>https://www.crestron.com/Products/Lighting-Environment/Lighting-Fixture-Accessories/Interfaces/DIN-SACN-DMX]] must be added to the ShowRunnerCLC™ controlled hardware
11 11  ** DIN-SACN-DMX will have traditional DMX connection to the third-party controller and receive ordinary DMX (non-eDMX) signals from the third-party controller
12 12  ** DIN-SACN-DMX must be on the lighting control LAN/VLAN