Changes for page DMX Input via Pharos

Last modified by Alexander Mott on 2024/06/14 18:25
From version 2.1
edited by Mark Kohlmann
on 2020/08/12 19:33
Change comment: There is no comment for this version
To version 1.1
edited by Mark Kohlmann
on 2020/08/12 19:33
Change comment: Uploaded new attachment "1597260805025-107.png", version {1}

Summary

Details

Page properties
Title
... ... @@ -1,1 +1,0 @@
1 -DMX Input via Pharos
Parent
... ... @@ -1,1 +1,0 @@
1 -SHOWRUNNER™ User Guide & Wiki.SHOWRUNNER™ Appendix.WebHome
Content
... ... @@ -1,34 +1,0 @@
1 -SHOWRUNNER™ can accept commands from a Pharos' DMX input.  Note: Pharos recommends not using anymore than 50 channels on the DMX input.
2 -
3 -Steps:
4 -
5 -SHOWRUNNER™
6 -
7 -1. Enable UDP Listener in the SHOWRUNNER™ config:
8 -
9 - "UdpListener":
10 - {
11 - "ListenPort": 45794
12 - },
13 -
14 -Pharos Config:
15 -
16 -1. Create a new Pharos Project or Open an Existing One
17 -1. Go to Project->Project Features and set DMX In under Trigger to Enabled
18 -1. Go to Network->Select Controller with DMX Input->Interfaces and set the Serial Port to DMX Input
19 -1. Triggers
20 -11. Create a trigger on each DMX Input that you wish to send to SHOWRUNNER™
21 -11. Set Trigger Parameters:
22 -111. Channel: Channel # you wish to capture
23 -111. Changes in range: Minimum: 0 Maximum: 255
24 -11. New Action: Output Ethernet
25 -111. Enable Variables
26 -111. IP/Hostname: IP Address or Hostname of the processor running SHOWRUNNER™
27 -111. Port: 45794
28 -111. Protocol: UDP
29 -111. String: "GID.SetLevelByByte.<3>\r"
30 -1111. GID is the GlobalID for the load within SHOWRUNNER™
31 -111. Example DMX Channel 41 controlling load with global ID of 32:
32 -[[image:1597260805025-107.png||height="58" width="693"]]
33 -
34 -