Skip to Content

Wiki source code of *GLS-SIM

Last modified by Alexander Mott on 2024/01/05 18:22
Hide last authors
Alexander Mott 1.1 1 (% class="row" %)
2 (((
3 (% class="col-xs-12 col-sm-8" %)
4 (((
Alexander Mott 3.1 5 (% class="box warningmessage" %)
6 (((
7 Note: GLS-SIM come with two dials labeled "HI" and "LO" which are used for setting the GLS-SIM's network address. These dials should be left at the factory "00" position unless specifically instructed to change them - if these dials are set to anything else then the address for the GLS-SIM cannot be changed via software and is only able to be changed using the dials.
8 )))
9
Alexander Mott 1.1 10 Lorem
11
12 See //[[Figure 1>>WebHome||anchor="HFigure1"]]// for details.
Alexander Mott 2.1 13 See //[[Figure 2>>WebHome||anchor="HFigure2"]]// for details.
Alexander Mott 1.1 14
15 = Device Wiring =
16
Alexander Mott 5.1 17 GLS-SIMs have two distinct sensor ports, allowing for up to two distinct inputs on each GLS-SIM. Inputs can come from any number of devices, including occupancy sensors, photocells, key switches, and contact closures.
Alexander Mott 1.1 18
19 == Occupancy Sensor ==
20
Alexander Mott 5.1 21 All occupancy sensors to be used with a GLS-SIM must be a "non-system" sensor. Cresnet or ZUMLINK sensors should be connected via Cresnet or ZUMLINK instead of the sensor port of a GLS-SIM.
Alexander Mott 1.1 22
Alexander Mott 2.1 23 == Photocell (Daylight Sensor) ==
Alexander Mott 1.1 24
25 Lorem
26
Alexander Mott 2.2 27 == Key Switch ==
Alexander Mott 1.1 28
Alexander Mott 5.1 29 There are two primary kinds of key switches: momentary and maintained. In addition to official Crestron key switches, there are third party manufacturers of key switches and buttons which can be used as inputs for a GLS-SIM.
Alexander Mott 1.1 30
Alexander Mott 5.1 31 === Crestron Momentary ===
Alexander Mott 2.1 32
Alexander Mott 5.1 33 ==== ====
Alexander Mott 2.1 34
Alexander Mott 5.1 35 === Crestron Maintained ===
36
37 Note: feedback is not available on maintained key switches, since the feedback status of the switch is apparant from the position of the key.
38
39 === Other Manufacturers ===
40
41
Alexander Mott 3.1 42 = DIP Switches =
Alexander Mott 1.1 43
Alexander Mott 3.1 44 Every GLS-SIM has four DIP switches which can be used to adjust the behavior and function of the two sensor ports on the GLS-SIM. For every DIP switch, the "up" position corresponds to "on", while the "down" position corresponds to "off". Switches 1 and 2 correspond to sensor port 1, while switches 2 and 3 correspond to sensor port 2.
Alexander Mott 2.2 45
Alexander Mott 3.1 46 The table below covers the function of each of the DIP switches and their affect on the GLS-SIM.
Alexander Mott 2.2 47
48 (% class="table-condensed" %)
49 |(% style="width:50px" %)**Port**|(% style="width:92px" %)**DIP Switch**|(% style="width:85px" %)**Setting**|(% style="width:757px" %)**Result**
50 |(% rowspan="4" style="width:50px" %)1|(% rowspan="2" style="width:92px" %)1|(% style="width:85px" %)On (Up)|(% style="width:757px" %)Disables pull-up resistor for port 1
51 |(% style="width:85px" %)Off (Down)|(% style="width:757px" %)Enables pull-up resistor on port 1 (port 1 will output 5V)
52 |(% rowspan="2" style="width:92px" %)2|(% style="width:85px" %)On (Up)|(% style="width:757px" %)Normal polarity (high input reads as "true")
53 |(% style="width:85px" %)Off (Down)|(% style="width:757px" %)Inverted polarity (high input reads as "false")
54 |(% rowspan="4" style="width:50px" %)2|(% rowspan="2" style="width:92px" %)3|(% style="width:85px" %)On (Up)|(% style="width:757px" %)Disables pull-up resistor for port 2
55 |(% style="width:85px" %)Off (Down)|(% style="width:757px" %)Enables pull-up resistor on port 2 (port 2 will output 5V)
56 |(% rowspan="2" style="width:92px" %)4|(% style="width:85px" %)On (Up)|(% style="width:757px" %)Normal polarity (high input reads as "true")
57 |(% style="width:85px" %)Off (Down)|(% style="width:757px" %)Inverted polarity (high input reads as "false")
58
59 == Occupancy Sensor ==
60
Alexander Mott 1.1 61 Lorem
62
Alexander Mott 2.2 63 == Photocell (Daylight Sensor) ==
Alexander Mott 1.1 64
65 Lorem
66
Alexander Mott 2.2 67 == Key Switch ==
Alexander Mott 1.1 68
69 Lorem
70
71 = Troubleshooting =
Alexander Mott 3.1 72
73
Alexander Mott 1.1 74 )))
75
76
77 (% class="col-xs-12 col-sm-4" %)
78 (((
79 {{box title="**CONTENTS**"}}
80 {{toc/}}
81 {{/box}}
82
83 (% class="wikigeneratedid" id="HFigure1" %)
84 (((
85 [[image:Templates.Article.Template.WebHome@image1.jpg]]
86 //Figure 1: [[Sea>>https://commons.wikimedia.org/wiki/File:Isle_of_Icacos_II.jpg]]//
87 )))
88
89 (% class="wikigeneratedid" id="HFigure2" %)
90 (((
91 [[image:Templates.Article.Template.WebHome@image2.jpg]]
92 //Figure 2: [[Waves>>https://commons.wikimedia.org/wiki/File:Culebra_-_Playa_de_Flamenco.jpg]]//
93 )))
94 )))
95 )))