*GLS-SIM

Last modified by Alexander Mott on 2024/01/05 18:22

Note: GLS-SIM come with two dials labeled "HI" and "LO" which are used for setting the GLS-SIM's network address. These dials should be left at the factory "00" position unless specifically instructed to change them - if these dials are set to anything else then the address for the GLS-SIM cannot be changed via software and is only able to be changed using the dials.

Lorem

See Figure 1 for details.
See Figure 2 for details.

Device Wiring

GLS-SIMs have two distinct sensor ports, allowing for up to two distinct inputs on each GLS-SIM. Inputs can come from any number of devices, including occupancy sensors, photocells, key switches, and contact closures. 

Occupancy Sensor

All occupancy sensors to be used with a GLS-SIM must be a "non-system" sensor. Cresnet or ZUMLINK sensors should be connected via Cresnet or ZUMLINK instead of the sensor port of a GLS-SIM. 

Photocell (Daylight Sensor)

Lorem

Key Switch

There are two primary kinds of key switches: momentary and maintained. In addition to official Crestron key switches, there are third party manufacturers of key switches and buttons which can be used as inputs for a GLS-SIM.

Crestron Momentary

Crestron Maintained

Note: feedback is not available on maintained key switches, since the feedback status of the switch is apparant from the position of the key.

Other Manufacturers

DIP Switches

Every GLS-SIM has four DIP switches which can be used to adjust the behavior and function of the two sensor ports on the GLS-SIM. For every DIP switch, the "up" position corresponds to "on", while the "down" position corresponds to "off". Switches 1 and 2 correspond to sensor port 1, while switches 2 and 3 correspond to sensor port 2. 

The table below covers the function of each of the DIP switches and their affect on the GLS-SIM.

PortDIP SwitchSettingResult
11On (Up)Disables pull-up resistor for port 1
Off (Down)Enables pull-up resistor on port 1 (port 1 will output 5V)
2On (Up)Normal polarity (high input reads as "true")
Off (Down)Inverted polarity (high input reads as "false")
23On (Up)Disables pull-up resistor for port 2
Off (Down)Enables pull-up resistor on port 2 (port 2 will output 5V)
4On (Up)Normal polarity (high input reads as "true")
Off (Down)Inverted polarity (high input reads as "false")

Occupancy Sensor

Lorem

Photocell (Daylight Sensor)

Lorem

Key Switch

Lorem

Troubleshooting