Skip to Content

Changes for page Ethernet Wiring Overview

Last modified by Alexander Mott on 2024/01/05 18:55
From version 35.2
edited by Alexander Mott
on 2024/01/05 18:55
Change comment: Update document after refactoring.
To version 36.1
edited by Alexander Mott
on 2024/01/05 18:55
Change comment: Renamed back-links.

Summary

Details

Page properties
Content
... ... @@ -23,7 +23,7 @@
23 23  
24 24  While either T568A or T568B termination pin-out are acceptable as long as they are used consistently, it is recommended to use the T568B pin-out for all terminations. By keeping to one standard, it is easier to stay consistent and prevent errors where the two sides of a single cable are not terminated to the same standard.
25 25  
26 -See //[[Figure 1>>doc:SHOWRUNNER™ Setup Guide.Troubleshooting Guide.Hardware and Installation.Ethernet Wiring Overview.WebHome||anchor="HFigure1"]]// for the T568-B pin-out.
26 +See //[[Figure 1>>doc:WebHome||anchor="HFigure1"]]// for the T568-B pin-out.
27 27  
28 28  When making RJ-45 terminations, take care that the wires are in the correct order and pushed all the way to the end of the connector. A crimping tool with sharp blades that have not been dulled with use also helps in making good terminations.
29 29