Skip to Content

Changes for page Ethernet Wiring Overview

Last modified by Alexander Mott on 2024/01/05 18:55
From version 3.4
edited by Alexander Mott
on 2021/12/20 23:36
Change comment: There is no comment for this version
To version 3.3
edited by Alexander Mott
on 2021/12/20 23:25
Change comment: There is no comment for this version

Summary

Details

Page properties
Title
... ... @@ -1,1 +1,1 @@
1 -Ethernet
1 +*Ethernet
Content
... ... @@ -8,27 +8,19 @@
8 8  (((
9 9  = Ethernet Wiring =
10 10  
11 -Ethernet is used for various devices within a Crestron Lighting Control system, including connecting a lighting control processor to the lighting network, connecting Zūm Net devices to the lighting network, connecting TSW touch-screen interfaces to the lighting network, and connecting the lighting network itself to a building network (building LAN).
11 +Ethernet wiring is used for various devices within a Crestron Lighting Control system, including connecting a lighting control processor to the lighting network, connecting Zūm Net devices to the lighting network, and connecting TSW touch-screen interfaces to the lighting network, among other devices.
12 12  
13 13  == Cabling ==
14 14  
15 -All cable should be Category 5e or greater (including Category 6 and Category 6a).
15 +All cable should be at least Category 5e, if not Category 6 or Category 6a. The
16 16  
17 -The maximum length of any single ethernet run is 100 meters (328 feet). Runs longer than this will require a powered ethernet switch (such as a CEN-SW-POE-5) to be installed midway through the run to enable proper communication.
18 -
19 19  == Terminations ==
20 20  
21 21  Cresnet Ethernet devices require the use of RJ-45 connectors.
22 22  
23 -While either T568A or T568B termination pin-out are acceptable as long as they are used consistently, it is **recommended to use the T568B pin-out for all terminations.** By keeping to one standard, it is easier to stay consistent and prevent errors where the two sides of a single cable are not terminated to the same standard.
21 +While either T568A or T568B termination pin-out are acceptable, it is **recommended to use the T568B pin-out for all terminations.** By keeping to one standard, it is easier to stay consistent and prevent errors where the two sides of a single cable are not terminated to the same standard.
24 24  
25 25  See// Figure 1 //for the T568-B pin-out.
26 -
27 -When making RJ-45 terminations, take care that the wires are in the correct order and pushed all the way to the end of the connector. A crimping tool with sharp blades that have not been dulled with use also helps in making good terminations.
28 -
29 -== Testing ==
30 -
31 -
32 32  )))
33 33  
34 34