Skip to Content
Last modified by Alexander Mott on 2024/01/05 18:55
From version 3.1
edited by Alexander Mott
on 2022/03/30 17:15
Change comment: There is no comment for this version
To version 2.2
edited by Alexander Mott
on 2022/03/30 17:07
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -8,21 +8,12 @@
8 8  (((
9 9  = Overview =
10 10  
11 -0-10V dimming is one of the most common dimming methods for LED fixtures. It utilizes a 0-10VDC signal from the lighting controller to the fixture power supply or driver in order to control the brightness of the fixtures. This 0-10VDC signal is typically carried over a shielded pair of gray (negative) and violet (positive) wires. In the event that 0-10V dimming fixtures are exhibiting unexpected dimming behavior, an easy place to begin troubleshooting is at the lighting control module.
11 +0-10V dimming is a common type of dimming protocol for LED fixtures. 0-10V dimming uses an analog DC signal in order to command the fixture driver to raise or lower the lights. The dimming signal is a steady voltage output between 0V and 10V, with lower voltages corresponding to a lower desired brightness.
12 12  
13 -== General Procedure ==
13 +== Sub-paragraph ==
14 14  
15 -Crestron produces a variety of 0-10V lighting controllers, and the specifics for troubleshooting them varies slightly. That being said, there is a general procedure for testing 0-10V dimming modules that is applicable to any type of 0-10V controller (even non-Crestron controllers).
15 +Lorem ipsum dolor sit amet, consectetur adipiscing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat. Duis aute irure dolor in reprehenderit in voluptate velit esse cillum dolore eu fugiat nulla pariatur. Excepteur sint occaecat cupidatat non proident, sunt in culpa qui officia deserunt mollit anim id est laborum.
16 16  
17 -
18 -The general 0-10V troubleshooting procedure is as follows:
19 -
20 -1. Identify the module and output that should be dimming the fixtures
21 -1. Disconnect the 0-10V wiring to the fixtures
22 -1. Connect a multimeter to the 0-10V dimming output of the module
23 -1. Measure the 0-10V output at various brightness levels
24 -*
25 -
26 26  == Sub-paragraph ==
27 27  
28 28  Lorem ipsum dolor sit amet, consectetur adipiscing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat. Duis aute irure dolor in reprehenderit in voluptate velit esse cillum dolore eu fugiat nulla pariatur. Excepteur sint occaecat cupidatat non proident, sunt in culpa qui officia deserunt mollit anim id est laborum.