Skip to Content
Last modified by Alexander Mott on 2024/01/05 18:55
From version 25.1
edited by Alexander Mott
on 2022/09/19 18:40
Change comment: Renamed back-links.
To version 26.1
edited by Scott Kohlmann
on 2023/04/21 14:17
Change comment: There is no comment for this version

Summary

Details

Page properties
Author
... ... @@ -1,1 +1,1 @@
1 -XWiki.alexander\.mott@chiefintegrations\.com
1 +XWiki.scott\.kohlmann@chiefintegrations\.com
Content
... ... @@ -12,7 +12,7 @@
12 12  1. Disconnect the 0-10V wiring to the fixtures
13 13  1. Connect a multimeter to the 0-10V dimming output of the module
14 14  1. Measure the 0-10V output at various brightness levels
15 -1*. If the system has been partially or fully commissioned, it may be possible to use the showrunner™ UI to adjust the brightness
15 +1*. If the system has been partially or fully commissioned, it may be possible to use the ShowRunnerCLC™ UI to adjust the brightness
16 16  1*. Alternatively, some modules have physical buttons that can be used to adjust their brightness:
17 17  1**. Press the button to toggle the output on or off. A small LED light on the module will indicate current output on/off status.
18 18  1**. Once the output is on, press and hold the button to cycle dim the output (first press and hold will lower the output, subsequent press and holds will toggle between raising and lowering the output)
... ... @@ -43,7 +43,7 @@
43 43  1. Identify the module and output that should be controlling the fixtures
44 44  1. Disconnect the 0-10V wiring to the fixtures
45 45  1. Toggle the module output on and off to verify it is switching the correct zone
46 -1*. If the system has been partially or fully commissioned, it may be possible to use the showrunner™ UI to toggle the module output
46 +1*. If the system has been partially or fully commissioned, it may be possible to use the ShowRunnerCLC™ UI to toggle the module output
47 47  1*. Alternatively, some modules have physical buttons that can be used to toggle the output:
48 48  1**. Press the button to toggle the output on or off. A small LED light on the module will indicate current output on/off status.
49 49  1**. Once the output is on, press and hold the button to cycle dim the output (first press and hold will lower the output, subsequent press and holds will toggle between raising and lowering the output)