Skip to Content
Last modified by Alexander Mott on 2024/01/05 18:55
From version 14.1
edited by Alexander Mott
on 2022/03/31 14:15
Change comment: There is no comment for this version
To version 15.1
edited by Alexander Mott
on 2022/03/31 14:20
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -18,7 +18,7 @@
18 18  1. Disconnect the 0-10V wiring to the fixtures
19 19  1. Connect a multimeter to the 0-10V dimming output of the module
20 20  1. Measure the 0-10V output at various brightness levels
21 -1*. If the system has been partially or fully commissioned, it may be possible to use the showrunner UI to adjust the brightness
21 +1*. If the system has been partially or fully commissioned, it may be possible to use the showrunner™ UI to adjust the brightness
22 22  1*. Alternatively, some modules have physical buttons that can be used to adjust their brightness:
23 23  1**. Press the button to toggle the output on or off. A small LED light on the module will indicate current output on/off status.
24 24  1**. Once the output is on, press and hold the button to cycle dim the output (first press and hold will lower the output, subsequent press and holds will toggle between raising and lowering the output)
... ... @@ -42,8 +42,15 @@
42 42  
43 43  == Verifying Fixture Wiring and Compatibility ==
44 44  
45 -There are a number of wiring and hardware issues that may result in
45 +There are a number of wiring and hardware issues that may result in fixtures not behaving as expected. Described below are some techniques that can help determine issues with wiring or hardware, however due to the wide variety of available fixtures and drivers it is not comprehensive.
46 46  
47 +1. Identify the module and output that should be controlling the fixtures
48 +1. Disconnect the 0-10V wiring to the fixtures
49 +1. Toggle the module output on and off to verify it is switching the correct zone
50 +1*. If the system has been partially or fully commissioned, it may be possible to use the showrunner™ UI to toggle the module output
51 +1*. Alternatively, some modules have physical buttons that can be used to toggle the output:
52 +1**. Press the button to toggle the output on or off. A small LED light on the module will indicate current output on/off status.
53 +1**. Once the output is on, press and hold the button to cycle dim the output (first press and hold will lower the output, subsequent press and holds will toggle between raising and lowering the output)
47 47  1. Reconnect the 0-10V wiring to the fixtures
48 48  1*. Verify that the positive and negative dimming wires are not crossed
49 49