Skip to Content

Changes for page Processor Setup

Last modified by Alexander Mott on 2024/12/02 19:04
From version 8.1
edited by Alexander Mott
on 2022/06/09 21:45
Change comment: There is no comment for this version
To version 10.1
edited by Alexander Mott
on 2022/06/09 22:38
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -39,6 +39,7 @@
39 39  *** Set IP subnet mask: ##ipm 0 255.255.255.0##
40 40  *** Set default gateway: ##defr 0 10.0.0.1##
41 41  *** Set hostname: ##host AP3-CPP##
42 +*** Reboot the processor: ##reboot##
42 42  ** It is also possible to configure a processor over Ethernet by using a DHCP server software on your laptop to assign an IP address
43 43  *** Configure your DHCP server software to assign IP addresses in the desired range
44 44  *** Once the processor is assigned an IP address, connect to it via Text Console at the assigned IP address
... ... @@ -55,7 +55,7 @@
55 55  * If the job has multiple processors, then these steps must be repeated for all processors on the job
56 56  ** For jobs with Central Control, the IP addresses of the processors matters
57 57  ** Chief Integrations will provide an SRTakeoff.xlsx spreadsheet with an IP Table tab that lists the IP address for each processor. If these IP addresses must be changed during startup, then it will be necessary to also change the IP addresses in the Remote System Definition in the configuration file
58 -** See the[[ CoAP Setup Guide for details>>doc:SHOWRUNNER™ Integrations Guide.Integration Options.CoAP with Crestron S# Library and Modules.CoAP ShowRunner to ShowRunner Setup Instructions.WebHome]]
59 +** See the[[ CoAP Setup Guide>>doc:SHOWRUNNER™ Integrations Guide.Integration Options.CoAP with Crestron S# Library and Modules.CoAP ShowRunner to ShowRunner Setup Instructions.WebHome]] for details
59 59  
60 60  === Program Load ===
61 61