Skip to Content

Changes for page Processor Setup

Last modified by Alexander Mott on 2024/12/02 19:04
From version 7.1
edited by Alexander Mott
on 2022/06/09 21:41
Change comment: There is no comment for this version
To version 9.1
edited by Alexander Mott
on 2022/06/09 22:33
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -55,7 +55,7 @@
55 55  * If the job has multiple processors, then these steps must be repeated for all processors on the job
56 56  ** For jobs with Central Control, the IP addresses of the processors matters
57 57  ** Chief Integrations will provide an SRTakeoff.xlsx spreadsheet with an IP Table tab that lists the IP address for each processor. If these IP addresses must be changed during startup, then it will be necessary to also change the IP addresses in the Remote System Definition in the configuration file
58 -** See the[[ CoAP Setup Guide for details>>doc:SHOWRUNNER™ Integrations Guide.Integration Options.CoAP with Crestron S# Library and Modules.CoAP ShowRunner to ShowRunner Setup Instructions.WebHome]]
58 +** See the[[ CoAP Setup Guide>>doc:SHOWRUNNER™ Integrations Guide.Integration Options.CoAP with Crestron S# Library and Modules.CoAP ShowRunner to ShowRunner Setup Instructions.WebHome]] for details
59 59  
60 60  === Program Load ===
61 61  
... ... @@ -74,7 +74,8 @@
74 74  ** Run the command ##sr ver##
75 75  ** If the console returns with the newly installed version of SHOWRUNNER™, then the installation was successful
76 76  ** If the console returns with "Bad or Incomplete Command (sr)" then the installation was not successful
77 -*** Right click on the PUF file and open the archive with your file archiver of choice (e.g. 7-Zip)
77 +*** Rename the .puf file to be a .zip file and open the archive
78 +**** Some file archivers (such as 7-Zip) allow you to right click on the PUF file and open the archive without changing the filetype
78 78  *** Extract the "CI.Lighting.ShowRunner.cpz" file
79 79  *** In Toolbox, connect to the processor via Text Console and click the lightning bolt icon and select "SIMPL Program..."
80 80  *** Under the "Send" section, browse your PC and select the extracted .cpz file