Skip to Content

Changes for page Processor Setup

Last modified by Alexander Mott on 2026/03/04 22:06
From version 57.1
edited by Alexander Mott
on 2025/04/30 15:55
Change comment: There is no comment for this version
To version 59.1
edited by Alexander Mott
on 2026/03/04 22:06
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -95,8 +95,11 @@
95 95  ** For jobs with Central Control, the IP addresses of the processors matters
96 96  ** Chief Integrations will provide an SRTakeoff.xlsx spreadsheet with an IP Table tab that lists the IP address for each processor. If these IP addresses must be changed during startup, then it will be necessary to also change the IP addresses in the Remote System Definition in the configuration file
97 97  ** See the[[ CoAP Setup Guide>>doc:SHOWRUNNER™ Integrations Guide.Integration Options.CoAP with Crestron S# Library and Modules.CoAP ShowRunner to ShowRunner Setup Instructions.WebHome]] for details
98 -* At this point, it is a good idea to [[update the device firmware>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.SHOWRUNNER™ Installation and Network Setup.Updating Firmware.WebHome]]
99 99  
99 += Firmware Update =
100 +
101 +At this point, it is a good idea to [[update the device firmware>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.SHOWRUNNER™ Installation and Network Setup.Updating Firmware.WebHome||anchor="HNetworkDevices"]], bearing in mind any device-specific firmware stepping requirements.
102 +
100 100  = Program Load =
101 101  
102 102  * Download the latest build of ShowRunnerCLC™ from the[[ Chief Integrations Portal>>https://files.chiefintegrations.com/index.php/s/WHNzXrrZbB5jC3E]]