Skip to Content

Changes for page Processor Setup

Last modified by Alexander Mott on 2025/04/30 15:55
From version 56.1
edited by Alexander Mott
on 2024/12/02 19:04
Change comment: There is no comment for this version
To version 54.1
edited by Alexander Mott
on 2024/12/02 18:59
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,12 +1,12 @@
1 -{{info}}
1 +(% class="box errormessage" %)
2 +(((
2 2  This page is for typical processor setup; for ZUM-HUB4 deployments, see our [[dedicated ZUM-HUB4 page>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.SHOWRUNNER™ Installation and Network Setup.ZUM-HUB4 Processor Setup.WebHome]].
3 -{{/info}}
4 4  
5 -{{error}}
6 6  All 4-Series processors require authentication to be configured when first connecting: **the Crestron Agent or Field Tech are responsible for recording these credentials. Chief Integrations cannot provide assistance unless the credentials are known. The only way to connect to a device for which the credentials have been lost is to factory reset the device, which may require redoing the start-up from scratch if the latest configuration was not saved and backed up. **
7 -{{/error}}
6 +)))
8 8  
9 -{{warning}}
8 +(% class="box warningmessage" %)
9 +(((
10 10  ShowRunnerCLC™™ is tested against current Crestron firmware releases. **Please use at least the recommended firmware builds.**
11 11  
12 12  * 3-Series: PUF 1.8001.0214
... ... @@ -17,7 +17,7 @@
17 17  
18 18  * Static IP or properly setup DHCP/DNS implementation required.
19 19  * Auto-Assigned/Link-Local IP address range of 169.254.x.x not supported (Crestron xPanel issue)
20 -{{/warning}}
20 +)))
21 21  
22 22  {{box cssClass="floatinginfobox" title="**CONTENTS**"}}
23 23  {{toc/}}