Skip to Content

Changes for page Processor Setup

Last modified by Alexander Mott on 2025/04/30 15:55
From version 55.1
edited by Alexander Mott
on 2024/12/02 19:00
Change comment: There is no comment for this version
To version 56.1
edited by Alexander Mott
on 2024/12/02 19:04
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,14 +1,12 @@
1 -(% class="box infomessage" %)
2 -(((
1 +{{info}}
3 3  This page is for typical processor setup; for ZUM-HUB4 deployments, see our [[dedicated ZUM-HUB4 page>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.SHOWRUNNER™ Installation and Network Setup.ZUM-HUB4 Processor Setup.WebHome]].
4 -)))
5 -(% class="box errormessage" %)
6 -(((
3 +{{/info}}
4 +
5 +{{error}}
7 7  All 4-Series processors require authentication to be configured when first connecting: **the Crestron Agent or Field Tech are responsible for recording these credentials. Chief Integrations cannot provide assistance unless the credentials are known. The only way to connect to a device for which the credentials have been lost is to factory reset the device, which may require redoing the start-up from scratch if the latest configuration was not saved and backed up. **
8 -)))
7 +{{/error}}
9 9  
10 -(% class="box warningmessage" %)
11 -(((
9 +{{warning}}
12 12  ShowRunnerCLC™™ is tested against current Crestron firmware releases. **Please use at least the recommended firmware builds.**
13 13  
14 14  * 3-Series: PUF 1.8001.0214
... ... @@ -19,7 +19,7 @@
19 19  
20 20  * Static IP or properly setup DHCP/DNS implementation required.
21 21  * Auto-Assigned/Link-Local IP address range of 169.254.x.x not supported (Crestron xPanel issue)
22 -)))
20 +{{/warning}}
23 23  
24 24  {{box cssClass="floatinginfobox" title="**CONTENTS**"}}
25 25  {{toc/}}