Skip to Content

Changes for page Processor Setup

Last modified by Alexander Mott on 2024/12/02 19:04
From version 52.1
edited by Alexander Mott
on 2024/03/27 15:23
Change comment: There is no comment for this version
To version 53.1
edited by Alexander Mott
on 2024/03/27 15:49
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -101,6 +101,14 @@
101 101  ** Double check that the correct PUF file is listed under the "Package Info" section and that the correct IP address is listed under "Target"
102 102  ** Press the "Recheck" button
103 103  ** Make sure that all three tasks are selected ("Load ShowRunner Program", "Update Crestron App", and "Update XPanel")
104 +** Additional tasks are available for certain processors:
105 +*** ZUM-HUB4:
106 +**** "Configure ZUM-HUB4" will automatically run commands: ##cwsanticsrf OFF## and ##startprogafterrouter on##
107 +**** "Configure ZUM-HUB4 Subnet" will automatically reconfigure the control subnet to a 100.64.0.0/20 configuration to avoid potential conflicts with corporate networks
108 +***** **NOTE: If you are connected to the Control Subnet and select this option, you will need to reconnect to the processor and run the .puf again in order to finish loading ShowRunnerCLC™ as this option will interrupt your connection to the processor.**
109 +**** "Configure ZUM-HUB4 SecureGateway" will automatically run command: ##securegateway default##
110 +*** Processors with Routers (AV3, CP3N, PRO3, AV4, CP4N, and PRO4)
111 +**** "Configure Processor with Router" will automatically run command: ##startprogafterrouter on##
104 104  ** Press the "Update" button to begin loading ShowRunnerCLC™
105 105  * Sometimes the PUF tool will falsely report a failure to load the program
106 106  ** Connect to the processor via Text Console