Skip to Content

Changes for page Processor Setup

Last modified by Alexander Mott on 2025/04/30 15:55
From version 51.1
edited by Alexander Mott
on 2024/03/27 15:23
Change comment: There is no comment for this version
To version 52.1
edited by Alexander Mott
on 2024/03/27 15:23
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -70,7 +70,7 @@
70 70  ** Never connect an external router to the Control Subnet, as doing so will cause the internal DHCP server to shut down.
71 71  ** Connect to the processor via Text Console and run the command: ##startprogafterrouter on##
72 72  *** This will force the processor to wait until the router has started before attempting to load the ShowRunnerCLC™ program, avoiding potential license validation issues if the processor boots up before the router.
73 -*** **ShowRunnerCLC™ .puf versions 3.042 and newer include this command in the "Configure Processor with Router" option.**
73 +*** ShowRunnerCLC™ .puf versions 3.042 and newer automatically run this command when the "Configure Processor with Router" option is selected.
74 74  ** The previously listed "ipa," "ipm," etc. commands will configure settings for the processor's LAN port, which should be connected to the building LAN or third party network.
75 75  ** Lighting control hardware (e.g. TSWs, DIN-CENCN-2s, etc.) should be left in DHCP mode and connected to the Control Subnet port.
76 76  *** The processor acts as a DHCP server on the Control Subnet, with addresses that are determined automatically based on the LAN configuration.