Skip to Content

Wiki source code of CEN-GWEXER Setup

Version 2.3 by Alexander Mott on 2023/12/04 16:52
Show last authors
1 {{box cssClass="floatinginfobox" title="**CONTENTS**"}}
2 {{toc/}}
3 {{/box}}
4
5 CEN-GWEXERs are a two-way radiofrequency (RF) transceivers that allow Crestron infinetEX and Extended Range wireless devices to communicate with the control processor over Ethernet. They are for Crestron wireless systems what [[DIN-CENCN-2s>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.SHOWRUNNER™ Installation and Network Setup.DIN-CENCN-2 Setup.WebHome]] are for wired Cresnet systems.
6
7 For SHOWRUNNER™ installations, the IP address of the CEN-GWEXER does not matter as long as it is in the same range as the processor and does not conflict with any other devices on the network. Instead, CEN-GWEXERs are identified to the processor via their IP-ID. Note that which infinetEX devices are landed at which CEN-GWEXER matters, and if devices are moved between CEN-GWEXERs then the configuration will need to be updated (see below). Chief Integrations typically provides an SRTakeoff.xlsx spreadsheet with an IP Table tab that lists all the CEN-GWEXER IP-IDs in the program. If no takeoff is provided, then the processor's IP table can be checked by running the ##ipt -t ##command from the processor after the configuration is loaded. DIN-CENCN-2's will typically have IP-IDs in the "##Cx##" range.
8
9 = IP Configuration =
10
11 Lorem
12
13 = SSL Setup =
14
15 Lorem
16
17 = RF Channel =
18
19 Lorem
20
21 = Useful Commands and Other Notes =
22
23 Lorem
24
25 == Acquiring Devices ==
26
27 Lorem
28
29 == Moving/Removing Devices (Unacquiring Devices) ==
30
31 When a wireless Crestron device is acquired to a new gateway using the typical acquiring process described above, it will automatically forget the previously connected gateway. The gateway itself, however, must manually "forget" the previously connected device before a newly acquired and addressed device will function correctly. This is necessary whether the originally connected device is moved or if the originally corrected device has failed and is being replaced.