Skip to Content

Changes for page Crestron RF Gateway Setup

Last modified by Alexander Mott on 2025/03/12 17:16
From version 9.1
edited by Alexander Mott
on 2023/12/12 00:02
Change comment: There is no comment for this version
To version 10.1
edited by Alexander Mott
on 2024/02/09 00:31
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -10,8 +10,24 @@
10 10  
11 11  Typically, each CEN-GWEXER will need to be initially configured via USB (micro USB), unless their MAC addresses are already known and the lighting network has a DHCP server (either by running DHCP server software on your computer, or if the processor has a control subnet or is running the [[ShowRunner™ DHCP Server>>doc:SHOWRUNNER™ Setup Guide.Troubleshooting Guide.Advanced Tools.DHCP Server.WebHome]]).
12 12  
13 -CEN-GWEXERs for the first time, it may be necessary to manually change the connection type from "Auto" to "SSL/TLS". It is also necessary to manually edit the CEN-GWEXER's address book entry so that the connection protocol is "SSL/TLS" when a CEN-GWEXER is added to the address book using Device Discovery tool export.
13 +When connecting to a CEN-GWEXER for the first time, it may be necessary to manually change the connection type from "Auto" to "SSL/TLS". It is also necessary to manually edit the CEN-GWEXER's address book entry so that the connection protocol is "SSL/TLS" when a CEN-GWEXER is added to the address book using Device Discovery tool export.
14 14  
15 +== DHCP Configuration ==
16 +
17 +If the lighting network is a managed network with a permanent DHCP server (or if it is on the Control Subnet of a CP4N, ZUM-HUB4, or other Crestron processor with a dedicated Control Subnet), then the hardware can be left in DHCP mode and only the IP table and hostname should be updated:
18 +
19 +* Connect to the CEN-GWEXER via Ethernet or USB (process is the same either way)
20 +* Open Text Console in Toolbox and connect to the CEN-GWEXER
21 +** Note that you may need to manually select "SSL" connection type, as "Auto" might not always redirect
22 +* Run the following commands to configure the CEN-GWEXER's IP table and hostname
23 +** Update IP table: ##addm (% style="color:olive" %)**C1**(%%) (% style="color:orange" %)**10.0.0.10**(%%)##
24 +** Set hostname: ##host (% style="color:purple" %)**GWEXER-L1**(%%)##
25 +** Reboot the CEN-GWEXER: ##reboot##
26 +* At this point, it is a good idea to [[update the device firmware>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.SHOWRUNNER™ Installation and Network Setup.Updating Firmware.WebHome]]
27 +* Repeat for all CEN-GWEXERs on the job
28 +
29 +== Static Configuration ==
30 +
15 15  Whether connected to the CEN-GWEXER via USB or Ethernet, the process to configure the static IP addresses is the same:
16 16  
17 17  * Open Text Console in Toolbox and connect to the CEN-GWEXER