Skip to Content

Changes for page Crestron RF Gateway Setup

Last modified by Alexander Mott on 2025/03/12 17:16
From version 4.1
edited by Alexander Mott
on 2023/12/04 17:05
Change comment: There is no comment for this version
To version 4.2
edited by Alexander Mott
on 2023/12/04 17:41
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -14,20 +14,37 @@
14 14  
15 15  Lorem
16 16  
17 +~/~/https:~/~/wiki.chiefintegrations.com/SHOWRUNNER%E2%84%A2%20User%20Guide%20%26%20Wiki/SHOWRUNNER%E2%84%A2%20Appendix/SSL%20User%20Configuration/
18 +SSL setup on proc
19 +SSL setup on devices
20 +
21 +~/~/Need to manually set SSL/TSL method for connecting to gwexer with auth enabled
22 +- also need to update address book if gwexer are added to address book (defaults to ctp)
23 +
17 17  = RF Channel =
18 18  
19 19  Lorem
20 20  
21 -= Useful Commands and Other Notes =
28 +~/~/"RFCHAnnel [#]" set rf channel for gwexer
22 22  
23 -Lorem
30 += Acquiring Devices =
24 24  
25 -== Acquiring Devices ==
32 +~/~/1-2-3-hold on 4 until all lights blink, then release
33 +top light will blink slowly a few times and then hold solid or start blinking rapidly
34 +if rapid blinking, cancel acquire and make sure that rf gateway is in acquire mode and device is in range then repeat to put device into acquire mode
26 26  
27 -Lorem
36 +== Text Console ==
28 28  
29 -== Moving/Removing Devices (Unacquiring Devices) ==
38 +~/~/"acquire start" and "acquire stop"
30 30  
40 +~/~/"rep" to show acquired devices
41 +
42 +== Gateway Configuration Tool ==
43 +
44 +~/~/Connect > functions > gateway configuration for better acquiring tool
45 +
46 += Moving/Removing Devices (Unacquiring Devices) =
47 +
31 31  When a wireless Crestron device is acquired to a new gateway using the typical acquiring process described above, it will automatically forget the previously connected gateway. The gateway itself, however, must manually "forget" the previously connected device before a newly acquired and addressed device will function correctly. This is necessary whether the originally connected device is moved or if the originally corrected device has failed and is being replaced.
32 32  
33 33  To unacquire a device from a gateway, it is necessary to run the below commands, replacing "[TSID]" with either the 4-byte hexadecimal TSID of a single device or "all" to forget all previously acquired devices. Devices do not need to be online in order to be acquired (e.g., a failed device can still be unacquired using this method). While only one of these commands needs to be run per device, it is not documented which command (ending in "0" or "1") is required for each model, so it is generally advisable to run both commands for each device to be unacquired: