Skip to Content

Changes for page Crestron RF Gateway Setup

Last modified by Alexander Mott on 2025/03/12 17:16
From version 12.1
edited by Alexander Mott
on 2024/02/09 00:39
Change comment: There is no comment for this version
To version 14.1
edited by Alexander Mott
on 2024/02/09 00:54
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -19,8 +19,8 @@
19 19  * Connect to the CEN-GWEXER via Ethernet or USB (process is the same either way)
20 20  * Open Text Console in Toolbox and connect to the CEN-GWEXER
21 21  ** Note that you may need to manually select "SSL" connection type, as "Auto" might not always redirect
22 -* Run the following commands to configure the CEN-GWEXER's IP table and hostname
23 -** Update IP table: ##addm (% style="color:olive" %)**C1**(%%) (% style="color:orange" %)**10.0.0.10**(%%)##
22 +* Run the following commands to configure the CEN-GWEXER's IP table and hostname (example is for an IP-ID of (% style="color:olive" %)**C1**(%%), and a target processor IP address of (% style="color:orange" %)**172.22.0.1**(%%), and a device hostname of (% style="color:purple" %)**GWEXER-L1**(%%))
23 +** Update IP table: ##addm (% style="color:olive" %)**C1**(%%) (% style="color:orange" %)**172.22.0.1**(%%)##
24 24  ** Set hostname: ##host (% style="color:purple" %)**GWEXER-L1**(%%)##
25 25  ** Reboot the CEN-GWEXER: ##reboot##
26 26  * At this point, it is a good idea to [[update the device firmware>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.SHOWRUNNER™ Installation and Network Setup.Updating Firmware.WebHome]]
... ... @@ -28,7 +28,7 @@
28 28  
29 29  == Static Configuration ==
30 30  
31 -If there is no permanent DHCP server on the lighting network, then CEN-GWEXERs should be configured with static IP addresses. If a temporary DHCP server is connected to the lighting network and the CEN-GWEXER MAC addresses are known, then the devices can be set up via Ethernet from one location, otherwise they will need to be set up via USB. Whether connected to the CEN-GWEXER via USB or Ethernet, the process to configure the static IP addresses is the same:
31 +If there is no permanent DHCP server on the lighting network, then CEN-GWEXERs should be configured with static IP addresses via USB (Micro USB). If a temporary DHCP server is connected to the lighting network and you are able to identify CEN-GWEXERs by MAC address, then it is possible to configure these settings via Ethernet using Text Console. Whether connected via USB or Ethernet, the process to configure the static IP addresses is the same:
32 32  
33 33  * Open Text Console in Toolbox and connect to the CEN-GWEXER
34 34  ** Note that you may need to manually select "SSL" connection type, as "Auto" might not always redirect