Skip to Content

Changes for page Crestron RF Gateway Setup

Last modified by Alexander Mott on 2025/03/12 17:16
From version 12.1
edited by Alexander Mott
on 2024/02/09 00:39
Change comment: There is no comment for this version
To version 13.1
edited by Alexander Mott
on 2024/02/09 00:48
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -19,8 +19,8 @@
19 19  * Connect to the CEN-GWEXER via Ethernet or USB (process is the same either way)
20 20  * Open Text Console in Toolbox and connect to the CEN-GWEXER
21 21  ** Note that you may need to manually select "SSL" connection type, as "Auto" might not always redirect
22 -* Run the following commands to configure the CEN-GWEXER's IP table and hostname
23 -** Update IP table: ##addm (% style="color:olive" %)**C1**(%%) (% style="color:orange" %)**10.0.0.10**(%%)##
22 +* Run the following commands to configure the CEN-GWEXER's IP table and hostname (example is for an IP-ID of (% style="color:olive" %)**C1**(%%), and a target processor IP address of (% style="color:orange" %)**172.22.0.1**(%%), and a device hostname of (% style="color:purple" %)**GWEXER-L1**(%%))
23 +** Update IP table: ##addm (% style="color:olive" %)**C1**(%%) (% style="color:orange" %)**172.22.0.1**(%%)##
24 24  ** Set hostname: ##host (% style="color:purple" %)**GWEXER-L1**(%%)##
25 25  ** Reboot the CEN-GWEXER: ##reboot##
26 26  * At this point, it is a good idea to [[update the device firmware>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.SHOWRUNNER™ Installation and Network Setup.Updating Firmware.WebHome]]