Skip to Content

Changes for page Crestron RF Gateway Setup

Last modified by Alexander Mott on 2025/03/12 17:16
From version 11.1
edited by Alexander Mott
on 2024/02/09 00:33
Change comment: There is no comment for this version
To version 12.1
edited by Alexander Mott
on 2024/02/09 00:39
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -8,7 +8,7 @@
8 8  
9 9  = IP Configuration =
10 10  
11 -Typically, each CEN-GWEXER will need to be initially configured via USB (micro USB), unless their MAC addresses are already known and the lighting network has a DHCP server (either by running DHCP server software on your computer, or if the processor has a control subnet or is running the [[ShowRunner™ DHCP Server>>doc:SHOWRUNNER™ Setup Guide.Troubleshooting Guide.Advanced Tools.DHCP Server.WebHome]]).
11 +Typically, each CEN-GWEXER will need to be initially configured via USB (micro USB) unless their MAC addresses are already known and the lighting network has a DHCP server. If the DHCP server on the network is temporary (e.g. DHCP server software running on your computer or a processor utilizing the [[ShowRunner™ DHCP Server>>doc:SHOWRUNNER™ Setup Guide.Troubleshooting Guide.Advanced Tools.DHCP Server.WebHome]]), then static IP addresses must be configured. If the DHCP server is permanent (such as a CP4N or ZUM-HUB4 Control Subnet), then only the IP table needs to be configured for the devices.
12 12  
13 13  When connecting to a CEN-GWEXER for the first time, it may be necessary to manually change the connection type from "Auto" to "SSL/TLS". It is also necessary to manually edit the CEN-GWEXER's address book entry so that the connection protocol is "SSL/TLS" when a CEN-GWEXER is added to the address book using Device Discovery tool export.
14 14  
... ... @@ -28,7 +28,7 @@
28 28  
29 29  == Static Configuration ==
30 30  
31 -If there is no permanent DHCP server on the lighting network, then CEN-GWEXERs should be configured with static IP addresses. Whether connected to the CEN-GWEXER via USB or Ethernet, the process to configure the static IP addresses is the same:
31 +If there is no permanent DHCP server on the lighting network, then CEN-GWEXERs should be configured with static IP addresses. If a temporary DHCP server is connected to the lighting network and the CEN-GWEXER MAC addresses are known, then the devices can be set up via Ethernet from one location, otherwise they will need to be set up via USB. Whether connected to the CEN-GWEXER via USB or Ethernet, the process to configure the static IP addresses is the same:
32 32  
33 33  * Open Text Console in Toolbox and connect to the CEN-GWEXER
34 34  ** Note that you may need to manually select "SSL" connection type, as "Auto" might not always redirect