Wiki source code of Pharos Configuration

Version 1.2 by Alexander Mott on 2023/05/05 17:49

version	line-number	content
1.1	1	{{box cssClass="floatinginfobox" title="CONTENTS"}}
	2	{{toc/}}
	3	{{/box}}
	4
	5	(% class="row" %)
	6	(((
	7	ShowRunner™ can control DMX fixtures through several different methods, including Pharos DMX controllers. The most common Pharos controllers sold through Crestron are the Pharos LPC-1 (DIN-DMX-1UNIVERSE) and the Pharos LPC-2 (DIN-DMX-2UNIVERSE). These LPC controllers appear physically identical, but the LPC-1 shares a single universe across both DMX outputs while the LPC-2 has a separate universe for each output. ShowRunner™ uses the Pharos Controller API to send commands over Ethernet to the Pharos Controller, which then sends DMX commands to the fixtures.
	8
	9	= Pharos Project =
	10
1.2	11	Pharos projects are created using the free Pharos Designer 2 software from Pharos Controls. When creating a project for use with ShowRunner™, ensure that API version 5.0 is selected for the project. Individual loads control from ShowRunner™ is achieved with group-level commands using the Pharos Controller API, so each Fixture Group defined in the Pharos Project should correspond to a single load in ShowRunner™. In addition to group-level commands, ShowRunner™ also supports mapping ShowRunner™ Scenes to Pharos Timelines.
1.1	12
1.2	13	The basic steps for creating a Pharos Project for use with ShowRunner™ are:
1.1	14
1.2	15	1. Open the Pharos Designer 2 software
	16	1. In the top-right, click "New Project" and select the type of Pharos controller that will be the primary controller
	17	1*. Crestron SKUs DIN-DMX-1UNIVERSE and DIN-DMX-2UNIVERSE both correspond to "LPC" in Pharos
	18	1. Navigate to the "Project" page and verify that the API Version
1.1	19
1.2	20
1.1	21	The Pharos project layout can be as simple or as complicated as desired as long as the fixtures are grouped in a way that is compatible with ShowRunner™
	22
	23
	24	Due to limitations with the Pharos API, only single channel, RGB, or Intensity/CCT load types can be defined in ShowRunner™.
	25
	26	= Device Configuration =
	27
	28	= ShowRunner™ Configuration =
	29
	30
	31
	32	)))