Skip to Content

Changes for page Pharos Configuration

Last modified by Alexander Mott on 2024/02/26 15:10
From version 8.1
edited by Alexander Mott
on 2023/05/15 15:11
Change comment: There is no comment for this version
To version 7.1
edited by Alexander Mott
on 2023/05/10 15:49
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -173,10 +173,4 @@
173 173  ** Non-DMX loads in an area with Scene Tracking will still go to their predefined scene levels unless they are excluded from the scene
174 174  ** Pharos DMX loads will go to their predefined scene levels unless they are excluded from the scene, even if they are included in the Pharos Timeline being triggered
175 175  * If Timelines are being used to control DMX fixtures, then the Fixture Groups do not actually need to be defined in ShowRunner™ unless direct control of the Fixture Groups is desired
176 -
177 -= Fixture Addressing =
178 -
179 -Pharos Designer 2 has several features that make it relatively straightforward to address DMX fixtures, or to change how fixtures need to be addressed in order for the lighting controls to work correctly. Since ShowRunner™ uses fixture groups to send commands to DMX fixtures on the Pharos LPC, the specific fixture addresses do not matter as long as they are addressed according to the Pharos project. This means that if fixtures are re-patched to different addresses in the Pharos project but kept in the same fixture groups, then no changes to the ShowRunner™ configuration are necessary.
180 -
181 -In addition to allowing the re-patching of fixtures, Pharos LPC have Remote Device Management (RDM) capabilities that allow for remotely addressing DMX fixtures provided the fixtures are RDM capable. See our [[DMX Fixture Addressing page>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.Device Addressing.DMX Fixture Addressing.WebHome]] for more general information regarding DMX networks and fixture addressing for non-RDM capable fixtues.
182 182  )))