Skip to Content

Changes for page Pharos Configuration

Last modified by Alexander Mott on 2024/02/26 15:10
From version 4.1
edited by Alexander Mott
on 2023/05/05 21:59
Change comment: There is no comment for this version
To version 3.1
edited by Alexander Mott
on 2023/05/05 21:50
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -103,7 +103,7 @@
103 103  
104 104  = ShowRunner™ Configuration =
105 105  
106 -ShowRunner™ is able to control fixtures in Pharos by sending group-level commands directly to Fixture Groups that are defined in the Pharos project, triggering Timelines that are defined in the Pharos project, or both. Note that ShowRunner™ does not receive feedback from the Pharos controller, so fixture feedback as shown in the ShowRunner™ UI is only accurate if ShowRunner™ sent group-level commands. Changes to fixture levels caused by a Timeline are not reflected in the ShowRunner™ UI. A video tutorial of setting up Pharos loads and configuring Scene Tracking is [[available on our YouTube channel>>https://www.youtube.com/watch?v=Y63C_vnATec&list=PLhxgcngAeiD_pCRxFDwX5eg0O56OjNdHf]].
106 +ShowRunner™ is able to control fixtures in Pharos by sending group-level commands directly to Fixture Groups that are defined in the Pharos project, triggering Timelines that are defined in the Pharos project, or both. Note that ShowRunner™ does not receive feedback from the Pharos controller, so fixture feedback as shown in the ShowRunner™ UI is only accurate if ShowRunner™ sent group-level commands. Changes to fixture levels caused by a Timeline are not reflected in the ShowRunner™ UI.
107 107  
108 108  In order to control DMX fixtures on a Pharos controller with ShowRunner™, it is necessary to make sure that the ShowRunner™ configuration has the correct settings for the Pharos controller. Under the "LightingControllers" section of the ShowRunner™ configuration, locate the entry for the Pharos controller. Under the "Properties" section, verify that the "IpAddressOrHostname" matches the IP address or hostname of the Pharos controller. The "ApiPort" only needs to be changed if the HTTP port for the Pharos controller's web server has been changed from the default 80. Once the Properties for all Pharos controllers have been updated, load the configuration to the processor.
109 109