Changes for page Pharos Configuration

Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -113,6 +113,8 @@
113	113
114	114	= ShowRunner™ Configuration =
115	115
	116	+ShowRunner™ is able to control fixtures in Pharos by sending group-level commands directly to Fixture Groups that are defined in the Pharos project, triggering Timelines that are defined in the Pharos project, or both. Note that since fixt
	117	+
116	116	In order to control DMX fixtures on a Pharos controller with ShowRunner™, it is necessary to make sure that the ShowRunner™ configuration has the correct settings for the Pharos controller. Under the "LightingControllers" section of the ShowRunner™ configuration, locate the entry for the Pharos controller. Under the "Properties" section, verify that the "IpAddressOrHostname" matches the IP address or hostname of the Pharos controller. The "ApiPort" only needs to be changed if the HTTP port for the Pharos controller's web server has been changed from the default 80. Once the Properties for all Pharos controllers have been updated, load the configuration to the processor.
117	117
118	118	To add Pharos loads to ShowRunner™, launch the XPanel and navigate to the Settings > Load Configuration page and then select the Pharos controller from the list of controllers on the left. Once the controller is selected, press the "Configure Loads" button:
...	...	@@ -119,7 +119,7 @@
119	119
120	120	* All currently defined loads are shown on the left
121	121	** The "Group: #" of the load must match the group number as defined in the Pharos project
122		-** It is not possible to change the group of an existing load from the XPanel UI. Instead, either pull the config and edit the "LoadBaseIndex" property of the load
	124	+** It is not possible to change the group of an existing load from the XPanel UI. Instead, either save the config and edit the "LoadBaseIndex" property of the load, or delete the load and create a new load at the correct group
123	123	* To add a new load to the controller, press "Add New Load" below the list of loads
124	124	** The "Load Index/Channel" must match the group number as defined in the Pharos project
125	125	*** Since ShowRunner™ uses group-level commands and fixtures in a group aren't necessarily on the same DMX universe, the "Universe ID" is grayed out and cannot be modified
...	...	@@ -139,6 +139,8 @@
139	139	** If controlling the RGB and White channels of an RGBW fixture separately, then you must define an RGB type load associated with the RGB fixture group in Pharos and then a Single Channel type load associated with the White fixture group in Pharos
140	140	** The Area Assignment dictates what area the load will be associated with
141	141
	144	+ShowRunner™ is also capable of triggering Timelines in the Pharos project.
142	142
143		-note no feeback
	146	+
	147	+Once scene tracking has been configured for an area, Pharos Timelines will be triggered regardless of whether the individual loads are actually defined in ShowRunner™ or not.
144	144	)))