Skip to Content

Changes for page Pharos Configuration

Last modified by Alexander Mott on 2024/02/26 15:10
From version 1.41
edited by Alexander Mott
on 2023/05/05 21:10
Change comment: (Autosaved)
To version 1.40
edited by Alexander Mott
on 2023/05/05 21:05
Change comment: (Autosaved)

Summary

Details

Page properties
Content
... ... @@ -115,12 +115,9 @@
115 115  
116 116  * All currently defined loads are shown on the left
117 117  ** The "Group: #" of the load must match the group number as defined in the Pharos project
118 -* To add a new load to the controller, press "Add New Load" below the list of loads
118 +* To add a new load to ShowRunner™, press "Add New Load" below the list of loads
119 119  ** The "Load Index/Channel" must match the group number as defined in the Pharos project
120 120  *** Since ShowRunner™ uses group-level commands and fixtures in a group aren't necessarily on the same DMX universe, the "Universe ID" is grayed out and cannot be modified
121 -*** It is not possible to assign multiple Pharos groups to the same load, and it is not possible to assign multiple loads to the same group
122 -**** To have a single load in ShowRunner™ control multiple Pharos groups, create a new group in the Pharos project that contains the other groups and then associate the ShowRunner™ load with the super-group
123 -**** To have multiple ShowRunner™ loads control the same set of fixtures, create multiple groups in the Pharos project and assign the same fixtures to all groups (this is useful e.g. to allow ShowRunner™ to control an HSIC fixture using either RGB or dynamic white without needing to change the Load Type)
124 124  ** The "Load Type" does not need to strictly match the fixture type as defined in the Pharos project, as the Pharos controller will do its own processing to mix the DMX output to achieve the desired color
125 125  *** "Single Channel" loads are interpreted by the Pharos as intensity only 
126 126  **** Fixture profiles with a dedicated channel for intensity (IRGB, HSI, HSIC, ICHS, etc.) will only adjust the intensity channel, leaving the color and color temperature unchanged
... ... @@ -131,7 +131,9 @@
131 131  *** "RGB" loads are interpreted by the Pharos as an intensity + specific red, green, and blue values
132 132  **** Fixture profiles with a dedicated channel for intensity (IRGB, HSI, HSIC, etc.) will use the load level sent by ShowRunner™ for intensity and then mix the other channels to match the RGB values
133 133  **** Fixture profiles without a dedicated intensity channel (RGB, RGBW, etc.) will mix the intensities for each color to attempt to match the color and overall intensity sent by ShowRunner™
134 -** To control the white channel of RGBW fixtures separately from the RGB channels, the white
131 +* It is not possible to assign multiple Pharos groups to the same load, and it is not possible to assign multiple loads to the same group
132 +** To have a single load in ShowRunner™ control multiple Pharos groups, it is necessary to create a group in the Pharos project that contains the other groups and then associate the ShowRunner™ load with the super-group
133 +** To have
135 135  
136 136  
137 137  note no feeback