Changes for page Pharos Configuration

Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -97,11 +97,13 @@
97	97	1*. If the controller is on a Control Subnet and you are connecting via the LAN, [[verify that port forwarding has been configured>>https://wiki.chiefintegrations.com/FAQ/I%20can%27t%20connect%20to%20my%20Pharos%20LPC%20on%20the%20Control%20Subnet]] and proceed to the next step
98	98	1*. If you do not see the controller online, but you are connecting to it over a routed network, proceed to the next step
99	99	1. Select a controller that is defined in the project
100		-1. In the Properties menu on the right, assign the Serial Number to the controller
101		-1*. If
	100	+1. In the Properties menu on the right, click the Serial Number dropdown menu and select the SN corresponding to the controller
	101	+1*. If you do not see the corresponding serial number, click the "Find..." button
	102	+1*. If you are connecting to the controller over a routed network, put the controller's IP address into this field
	103	+1*. If you are connecting to a controller on a Control Subnet from the LAN side of the processor, put the processor's LAN IP address followed by a colon and the external port number that corresponds to internal port 38008 of the controller. See our [[FAQ>>https://wiki.chiefintegrations.com/FAQ/I%20can%27t%20connect%20to%20my%20Pharos%20LPC%20on%20the%20Control%20Subnet]] for information
	104	+1. If there are multiple controllers in the project, repeat step 6 for all controllers
	105	+1. Once all controllers defined in the project have been assigned a serial number, press the "Upload" button
102	102
103		-If connecting to a Pharos controller located on the Control Subnet of a Crestron processor from the LAN side of the processor, then it is necessary to configure port forwarding on the processor before the project
104		-
105	105	= ShowRunner™ Configuration =
106	106
107	107	no feedback from dmx