Skip to Content

Changes for page Pharos Configuration

Last modified by Alexander Mott on 2024/02/26 15:10
From version 1.30
edited by Alexander Mott
on 2023/05/05 20:09
Change comment: (Autosaved)
To version 1.27
edited by Alexander Mott
on 2023/05/05 19:54
Change comment: (Autosaved)

Summary

Details

Page properties
Content
... ... @@ -78,23 +78,11 @@
78 78  
79 79  1. Open Pharos Designer 2 or an existing Pharos project
80 80  1. Connect to the Pharos controller using the USB-B port on the front of the controller
81 -1. Navigate to the "Network" page
82 -1. Select the Pharos controller from the list
83 -1*. If a Pharos project is open, controllers defined in the project will be displayed above the list of online controllers
84 -1*. If there are multiple online controllers, use the "Beacon" function to flash all the LEDs on the front of the controller and verify the correct one is selected
81 +1. Navigate to the Network tab and select the LPC
85 85  1. If the Pharos Designer 2 version is different than the firmware on the Pharos controller, then it is necessary to either update the controller by pressing the "Reload Firmware" button, or downgrade Pharos Designer 2 by downloading the appropriate version from Pharos Controls' website
86 86  1. Press the "Configure" button to open the network configuration menu
87 -1. Set DHCP mode to Static and configure the IP address, IP mask, default gateway, and DNS servers as required for your network
88 88  
89 -Once the Pharos controller is online, it is necessary to load the Pharos project to the controller:
90 90  
91 -1. Open the Pharos project in Pharos Designer 2
92 -1. Connect to the network that the Pharos controller is on, or connect to the controller directly via USB
93 -1. Navigate to the "Network" page in Pharos Designer 2
94 -1. Verify that all online controllers have firmware that matches the version of Pharos Designer 2 you are running, and update them if necessary
95 -1*. Online controllers are displayed below the list of controllers that are defined in the project
96 -1. Select the controller in the project
97 -
98 98  If connecting to a Pharos controller located on the Control Subnet of a Crestron processor from the LAN side of the processor, then it is necessary to configure port forwarding on the processor before the project
99 99  
100 100  = ShowRunner™ Configuration =