Changes for page Pharos Configuration

Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -80,7 +80,8 @@
80	80	1. Connect to the Pharos controller using the USB-B port on the front of the controller
81	81	1. Navigate to the "Network" page
82	82	1. Select the Pharos controller from the list
83		-1*. If a Pharos project is open, online controllers will be listed below
	83	+1*. If a Pharos project is open, controllers defined in the project will be displayed above the list of online controllers
	84	+1*. If there are multiple online controllers, use the "Beacon" function to flash all the LEDs on the front of the controller and verify the correct one is selected
84	84	1. If the Pharos Designer 2 version is different than the firmware on the Pharos controller, then it is necessary to either update the controller by pressing the "Reload Firmware" button, or downgrade Pharos Designer 2 by downloading the appropriate version from Pharos Controls' website
85	85	1. Press the "Configure" button to open the network configuration menu
86	86	1. Set DHCP mode to Static and configure the IP address, IP mask, default gateway, and DNS servers as required for your network
...	...	@@ -90,6 +90,9 @@
90	90	1. Open the Pharos project in Pharos Designer 2
91	91	1. Connect to the network that the Pharos controller is on, or connect to the controller directly via USB
92	92	1. Navigate to the "Network" page in Pharos Designer 2
	94	+1. Verify that all online controllers have firmware that matches the version of Pharos Designer 2 you are running, and update them if necessary
	95	+1*. Online controllers are displayed below the list of controllers that are defined in the project
	96	+1. Select the controller in the project
93	93
94	94	If connecting to a Pharos controller located on the Control Subnet of a Crestron processor from the LAN side of the processor, then it is necessary to configure port forwarding on the processor before the project
95	95