Skip to Content

Changes for page Pharos Configuration

Last modified by Alexander Mott on 2024/02/26 15:10
From version 1.28
edited by Alexander Mott
on 2023/05/05 19:59
Change comment: (Autosaved)
To version 1.29
edited by Alexander Mott
on 2023/05/05 20:04
Change comment: (Autosaved)

Summary

Details

Page properties
Content
... ... @@ -78,11 +78,19 @@
78 78  
79 79  1. Open Pharos Designer 2 or an existing Pharos project
80 80  1. Connect to the Pharos controller using the USB-B port on the front of the controller
81 -1. Navigate to the Network tab and select the LPC
81 +1. Navigate to the "Network" page
82 +1. Select the Pharos controller from the list
83 +1*. If a Pharos project is open, online controllers will be listed below
82 82  1. If the Pharos Designer 2 version is different than the firmware on the Pharos controller, then it is necessary to either update the controller by pressing the "Reload Firmware" button, or downgrade Pharos Designer 2 by downloading the appropriate version from Pharos Controls' website
83 83  1. Press the "Configure" button to open the network configuration menu
86 +1. Set DHCP mode to Static and configure the IP address, IP mask, default gateway, and DNS servers as required for your network
84 84  
88 +Once the Pharos controller is online, it is necessary to load the Pharos project to the controller:
85 85  
90 +1. Open the Pharos project in Pharos Designer 2
91 +1. Connect to the network that the Pharos controller is on, or connect to the controller directly via USB
92 +1. Navigate to the "Network" page in Pharos Designer 2
93 +
86 86  If connecting to a Pharos controller located on the Control Subnet of a Crestron processor from the LAN side of the processor, then it is necessary to configure port forwarding on the processor before the project
87 87  
88 88  = ShowRunner™ Configuration =