Skip to Content

Changes for page Pharos Configuration

Last modified by Alexander Mott on 2024/02/26 15:10
From version 1.28
edited by Alexander Mott
on 2023/05/05 19:59
Change comment: (Autosaved)
To version 1.26
edited by Alexander Mott
on 2023/05/05 19:49
Change comment: (Autosaved)

Summary

Details

Page properties
Content
... ... @@ -79,12 +79,8 @@
79 79  1. Open Pharos Designer 2 or an existing Pharos project
80 80  1. Connect to the Pharos controller using the USB-B port on the front of the controller
81 81  1. Navigate to the Network tab and select the LPC
82 -1. If the Pharos Designer 2 version is different than the firmware on the Pharos controller, then it is necessary to either update the controller by pressing the "Reload Firmware" button, or downgrade Pharos Designer 2 by downloading the appropriate version from Pharos Controls' website
83 -1. Press the "Configure" button to open the network configuration menu
82 +1. If the Pharos Designer 2 version is different than the firmware on the Pharos controller, then it is necessary to either update the controller by pressing "Reload Firmor downgrade Pharos Designer 2
84 84  
85 -
86 -If connecting to a Pharos controller located on the Control Subnet of a Crestron processor from the LAN side of the processor, then it is necessary to configure port forwarding on the processor before the project
87 -
88 88  = ShowRunner™ Configuration =
89 89  
90 90  no feedback from dmx