Skip to Content

Changes for page Pharos Configuration

Last modified by Alexander Mott on 2024/02/26 15:10
From version 1.26
edited by Alexander Mott
on 2023/05/05 19:49
Change comment: (Autosaved)
To version 1.25
edited by Alexander Mott
on 2023/05/05 19:44
Change comment: (Autosaved)

Summary

Details

Page properties
Content
... ... @@ -74,12 +74,9 @@
74 74  
75 75  = Device Configuration =
76 76  
77 -ShowRunner™ must be able to communicate with the Pharos controller via Ethernet in order for control to work. Pharos controllers ship in DHCP mode by default, but they will sometimes fail to get an address if the controller is powered up before the DHCP server is running. If this happens, or if there is no DHCP server on the network, then it is necessary to configure the controller via USB:
77 +ShowRunner™ must be able to communicate with the Pharos controller via Ethernet in order for control to work. Pharos controllers ship in DHCP mode by default, but they will sometimes fail to get an address if the controller is powered up before the DHCP server is running. If this happens, or if there is no DHCP server on the network, then it is necessary to configure the controller via USB.
78 78  
79 -1. Open Pharos Designer 2 or an existing Pharos project
80 -1. Connect to the Pharos controller using the USB-B port on the front of the controller
81 -1. Navigate to the Network tab and select the LPC
82 -1. If the Pharos Designer 2 version is different than the firmware on the Pharos controller, then it is necessary to either update the controller by pressing "Reload Firmor downgrade Pharos Designer 2
79 +1. Plug in to
83 83  
84 84  = ShowRunner™ Configuration =
85 85