Wiki source code of Startup Checklist

Version 6.1 by Alexander Mott on 2023/05/19 16:21

version	line-number	content
5.1	1	This is a broad-strokes checklist for what needs to be completed by a technician for a ShowRunnerCLC™ startup. This checklist is not 100% comprehensive and does not go into detail for each step.
1.1	2
5.1	3	More detailed specifics and troubleshooting information are available in the [[ShowRunnerCLC™ Startup Guide>>doc:SHOWRUNNER™ Setup Guide.WebHome]].
1.1	4
	5	Startup Checklist:
	6
	7	* Before arriving on-site:
	8	** Ensure you have the [[required tools and software>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.Preparation.Preparing to Go On-Site.WebHome]]
3.1	9	** Ensure the jobsite is meets [[site readiness requirements>>doc:SHOWRUNNER™ Setup Guide.SHOWRUNNER™ Installation Guide.Preparation.Site Readiness Checklist.WebHome]]
1.1	10	* Once on-site:
4.1	11	** Configure IP settings for networked devices (processors, TSW touch panels, DIN-CENCN-2s, ZUMNET-JBOXs, GLPACs, etc.)
1.1	12	** Configure clock and timezone for processors
	13	** Update firmware for all networked devices
	14	** If necessary, update firmware for Zūm Net and Cresnet devices
5.1	15	** Load ShowRunnerCLC™ program, license, and configuration file to the processor
	16	** Load the ShowRunnerCLC™ UI to any touchscreens
	17	** Load the ShowRunnerCLC™ expansion program to any GLPACs
4.1	18	** Configure the IP table for any required devices (TSW touch panels, DIN-CENCN-2s, ZUMNET-JBOXs, GLPACs, etc.)
1.1	19	** Poll Cresnet and verify devices are online in Toolbox
5.1	20	** Assign Cresnet IDs to devices and verify they are reporting online to ShowRunnerCLC™
1.1	21	** Verify load schedule and fixture functionality
6.1	22	*** Toggle each load individually and verify they dim and switch correctly
1.1	23	*** Verify loads are assigned to correct areas
	24	*** Assign friendly load labels as necessary
6.1	25	*** Use the "Verification" checkbox to add a verified timestamp to the load
1.1	26	** Verify occupancy sensors
	27	*** Verify correct area assignments
	28	*** Adjust timeouts and sensitivities as necessary
	29	** Verify keypad functionality
	30	*** Verify correct area assignments
	31	*** Verify correct button layouts and functionality
	32	** Verify photocell functionality
	33	*** Assign photocells to appropriate lighting zones and enable for required scenes
	34	*** Adjust sensitivity as necessary
	35	** Verify partition sensor functionality
	36	*** Verify correct area assignments
	37	*** Adjust sensitivity as required
	38	** Set up any schedules as required per the sequence of operations
2.1	39	** Complete functionality test (QC, make sure each room functions from an end-user perspective)
	40	** End-user training