Changes for page Shades Integrations

Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -74,7 +74,7 @@
74	74	* TCP/IP communication (including HTTP/HTTPS, TelNet, etc.)
75	75	** Standard [[Ethernet wiring limitations>>doc:SHOWRUNNER™ Setup Guide.Troubleshooting Guide.Troubleshooting.Ethernet Wiring Overview.WebHome]] apply
76	76
77		-Below is a non-exhaustive table showing which pieces of Crestron hardware have interfaces for each kind of integration:
	77	+Below is a non-exhaustive table showing which pieces of Crestron hardware have interfaces for each kind of integration (all processors are capable of TCP/IP integration provided the network has been configured correctly):
78	78
79	79	|=Hardware|=Relay Outputs|=RS-485 Serial Ports|=RS-232 Serial Ports
80	80	|C2N-IO|2|✖|1
...	...	@@ -96,7 +96,14 @@
96	96
97	97	=== Hardware Requirements ===
98	98
99		-* Two relays must be available for each shade controller
	99	+* Crestron devices with output relays must be specified (refer to table above for commonly specified hardware)
	100	+* Two Crestron output relays must be available for each zone of shades to be controlled
	101	+** Depending on the shade hardware and the job requirements, it may be possible to combine multiple shades to be controlled together onto a single pair of Crestron relays
	102	+** Contact Chief Integrations if the shades manufacturer specifies either more than two contact closures for third-party integration
	103	+* Standard command outputs are as follows:
	104	+** Open: close relay 1
	105	+** Close: close relay 2
	106	+** Stop: close both relays simultaneously
100	100	* It is recommended that shade interfaces be installed as close as possible to the Crestron relays controlling them to prevent issues from voltage drop or EMF in the wiring between the relay and the shade interface
101	101
102	102	=== Information Requirements ===