Changes for page Shades Integrations

Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -134,26 +134,22 @@
134	134
135	135	* For RS-232 integration:
136	136	** One RS-232 port on the ShowRunnerCLC™ system must be available for each MNI to be integrated
137		-** Depending on how the MechoNet system is designed, it may be possible to control many shades through a single RS-232 integration provided that any additional MNI and controlled MechoNet hardware is networked together and configured on the MechoNet side
	137	+** Depending on how the MechoNet system is configured, it is possible that multiple MNI can be controlled through the RS-232 connection at a single MNI
138	138	* For contact closure integration:
139	139	** Contact closure integration utilizes the MNI switch input ports: **it is not possible to use contact closure integration if Mecho switches are installed to control the shades**
140	140	** Two relays must be available for each Mecho motor to be controlled (it is possible to control multiple Mecho motors from a single relay pair provided that the MNI switch ports are wired in parallel)
141		-* For RS-485 or IR integration, reach out to Chief Integrations for potentially adding these integrations
	141	+* For RS-485 or IR integration, reach out to Chief Integrations
142	142
143	143	=== Information Requirements ===
144	144
145	145	Specific information requirements depend on which method of integration is required:
146	146
147		-* **(Required)** Specify whether integration is being done through RS-232 or contact closures
	147	+* **(Required) **Whether integration is being done through RS-232 or contact closures
148	148	* For RS-232 integration:
149		-** **(Required) **MechoNet devices must be addressed so that it is possible to control them per the SOO using their Zone, Group, Node addresses
150		-*** MechoNet devices are assigned three-part Zone, Group, Node addresses similar to an IPv4 address with 3 parts instead of 4
151		-*** e.g. a ZGN address of 128.151.253 represents a device in zone 128, group 151, and node 253
152		-** **(Required) **ZGN addresses must be provided for all shades to be controlled
153		-** **(Required)** location for each shade to be controlled so that they can be assigned to the correct areas in ShowRunnerCLC™
	149	+**
154	154	* For contact closure integration:
155	155	** **(Required)** all information specified in the [[general contact closure>>doc:SHOWRUNNER™ Integrations Guide.Integration Options.Shades Integrations.WebHome||anchor="HInformationRequirements"]] section above
156		-** **(Required)** indicate which Crestron relays correspond to each motor on each MNI, and which shades are controlled by each motor
	152	+** **(Required)** which shades are controlled by which motor output on each MNI, and which Crestron relays those outputs are expected to correspond to
157	157
158	158	== Mecho SolarTrac4 ==
159	159