Wiki source code of DMX Input via Pharos

Version 4.2 by Mark Kohlmann on 2021/07/14 16:24

version	line-number	content
2.1	1	SHOWRUNNER™ can accept commands from a Pharos' DMX input. Note: Pharos recommends not using anymore than 50 channels on the DMX input.
	2
	3	Steps:
	4
	5	SHOWRUNNER™
	6
3.1	7	1. Enable [[UDP Listener>>doc:SHOWRUNNER™ User Guide & Wiki.SHOWRUNNER™ Appendix.UDP Input.WebHome]] in the SHOWRUNNER™ config:
2.1	8
	9	"UdpListener":
	10	{
	11	"ListenPort": 45794
	12	},
	13
	14	Pharos Config:
	15
	16	1. Create a new Pharos Project or Open an Existing One
	17	1. Go to Project->Project Features and set DMX In under Trigger to Enabled
	18	1. Go to Network->Select Controller with DMX Input->Interfaces and set the Serial Port to DMX Input
	19	1. Triggers
	20	11. Create a trigger on each DMX Input that you wish to send to SHOWRUNNER™
	21	11. Set Trigger Parameters:
	22	111. Channel: Channel # you wish to capture
	23	111. Changes in range: Minimum: 0 Maximum: 255
	24	11. New Action: Output Ethernet
	25	111. Enable Variables
	26	111. IP/Hostname: IP Address or Hostname of the processor running SHOWRUNNER™
	27	111. Port: 45794
	28	111. Protocol: UDP
	29	111. String: "GID.SetLevelByByte.<3>\r"
	30	1111. GID is the GlobalID for the load within SHOWRUNNER™
	31	111. Example DMX Channel 41 controlling load with global ID of 32:
	32	[[image:1597260805025-107.png\|\|height="58" width="693"]]
	33
	34