Changes for page Crestron Zūm Wireless

Last modified by Scott Kohlmann on 2023/04/20 22:28
From version < 37.1 >
edited by Alexander Mott
on 2022/09/19 17:02
To version < 38.1 >
edited by Alexander Mott
on 2022/09/19 18:28
< >
Change comment: Renamed back-links.

Summary

Details

Page properties
Content
... ... @@ -39,7 +39,7 @@
39 39  |Custom Zūm Keypad Programming|(((
40 40  Y, per individual button (1 through 4)
41 41  AV Keypad not required (v3.004 or later)
42 -[[Details>>doc:SHOWRUNNER™ Setup Guide.Troubleshooting Guide.Software and Programming.Troubleshooting.Zummesh Keypad Custom Programming.WebHome]]
42 +[[Details>>doc:SHOWRUNNER™ Setup Guide.Troubleshooting Guide.Advanced Tools.Zummesh Keypad Custom Programming.WebHome]]
43 43  )))|Y, Zūm AV Keypad Only|N|N|Y, within the limits of the hardware
44 44  |New Feature Release Cycle|Aggressive|Aggressive|SHOWRUNNER™: Aggressive
45 45  Floor Hub: 6-12 months|6-12 months|6-12 months
... ... @@ -153,7 +153,7 @@
153 153  * Lower operations can turn the load off.  The load will not come on with a raise.  This is a firmware behavior in the Zum hardware.
154 154  * Wireless control presents some additional latency possibilities.  Commands required to provide full functionality (load control/raise/lower) with Zum wireless are more intensive than traditional Crestron hardware and may impact performance under heavy load.  Local operation of the Zum wireless room is not impacted.
155 155  * Real time load status is not available.  Any changes to loads performed using the raise/lower functions in room will not be propagated back to ShowRunner.  Levels set by the daylight sensor with daylighting enabled will not be reported by ShowRunner.
156 -* Keypad behaviors cannot be modified in ShowRunner.  Some modifications are permitted within the Zum app.  Custom keypads can be implemented using the AVBRIDGE connected to the system via a serial port, Zum requires an AV specific keypad for this purpose; or via export buttons ([[Details>>doc:SHOWRUNNER™ Setup Guide.Troubleshooting Guide.Software and Programming.Troubleshooting.Zummesh Keypad Custom Programming.WebHome]]).
156 +* Keypad behaviors cannot be modified in ShowRunner.  Some modifications are permitted within the Zum app.  Custom keypads can be implemented using the AVBRIDGE connected to the system via a serial port, Zum requires an AV specific keypad for this purpose; or via export buttons ([[Details>>doc:SHOWRUNNER™ Setup Guide.Troubleshooting Guide.Advanced Tools.Zummesh Keypad Custom Programming.WebHome]]).
157 157  * Zum Partition Sensors do not report back to the system and cannot be used to handle room divide/combine logic externally to the linked Zum rooms.
158 158  * Off Scene cannot be saved and is always room Off
159 159  * Scenes 1 through 16 are supported and may be modified and saved.

Navigation