Wiki source code of INETS-IOEX-DOOR-BATT
Last modified by Alexander Mott on 2020/09/11 23:02
Hide last authors
| author | version | line-number | content |
|---|---|---|---|
 |
2.1 | 1 | = Overview = |
| 2 | |||
| 3 | Crestron infiNET simplifies the installation process by enabling the installation of wireless devices, reducing the amount of time and material required for installation. Wireless devices communicate with the lighting control processor through a wireless gateway. In order for these devices to function, they must be "acquired" to the correct wireless gateway. Sometimes, it is possible that these devices lose the gateway and must be re-acquired to the gateway. | ||
| 4 | |||
| 5 | == Acquire the INETS-IOEX-DOOR-BATT == | ||
| 6 | |||
| 7 | To acquire or re-acquire an INETS-IOEX-DOOR-BATT door sensor to a gateway, complete the following steps: | ||
| 8 | |||
| 9 | 1. Put the wireless gateway into acquire mode by pressing the "Acquire" button | ||
| 10 | 1*. If there are multiple gateways, only put one into acquire mode at a time | ||
| 11 | 1. Locate the pinhole on the INETS-IOEX-DOOR-BATT and rapidly press it four times, holding on the fourth press for 12 seconds | ||
| 12 | 1*. A small pin is necessary to press this button | ||
| 13 | 1*. The button sequence is Press-Press-Press-Hold | ||
| 14 | 1. Release the button after the 12 second hold | ||
| 15 | 1*. The sensor will beep every 1.5 seconds while it tries to acquire to the gateway | ||
| 16 | 1*. If the sensor successfully acquires to the gateway, it will chirp once | ||
| 17 | 1*. If the sensor fails to acquire to the gateway, it will chirp three times | ||
| 18 | 1. Once all devices that are to be acquired to the gateway have been acquired, take the gateway out of acquire mode by pressing the "Acquire" button again | ||
| 19 | |||
| 20 | |||
| 21 | [[image:1599865340587-942.png]] |