Skip to Content
Last modified by Alexander Mott on 2024/01/05 18:55
From version 16.1
edited by Alexander Mott
on 2021/12/23 19:51
Change comment: There is no comment for this version
To version 19.1
edited by Alexander Mott
on 2021/12/29 16:15
Change comment: Uploaded new attachment "mg_qs_zumnet-jbox.pdf", version {1}

Summary

Details

Page properties
Content
... ... @@ -19,7 +19,7 @@
19 19  
20 20  It is important to note that while there are two ZUMLINK ports, Zūm Link runs should never be looped back to a ZUMNET-JBOX. Zūm Link runs should originate at a ZUMNET-JBOX, connect to a number of Zūm Link devices, and then stop at the last Zūm Link device. The reason for having multiple ZUMLINK ports is ease of installation; for example, if there are two ZUMLINK-KP keypads in a room, it might be easier to put them at the end of two separate runs so that only one RJ-45 terminated Zūm Link cable needs to be pulled through conduit.
21 21  
22 -In //[[Figure 1>>xwiki:Wiring Guide.Zūm Wired Systems.Load Controllers (ZUMNET-JBOX).WebHome||anchor="HFigure1"]]//, ZUMLINK ports are shown in orange, ZUMNET ports are shown in purple, and the sensor input block is between them.
22 +In //[[Figure 1>>xwiki:Wiring Guide.Zūm Wired System Overview.Load Controllers (ZUMNET-JBOX).WebHome||anchor="HFigure1"]]//, ZUMLINK ports are shown in orange, ZUMNET ports are shown in purple, and the sensor input block is between them.
23 23  
24 24  == ZUMNET-JBOX-16A-LV Wiring ==
25 25  
... ... @@ -35,7 +35,7 @@
35 35  
36 36  == Sensor Input Wiring Detail ==
37 37  
38 -Non-system sensors (including Crestron GLS-ODT-C-NS sensors, GLA-LDL photocells, and Steinel occupancy sensors) may be landed at the sensor input terminal block of ZUMNET-JBOX devices. Details on the sensor input wiring detail can be found [[here>>doc:Wiring Guide.Zūm Wired System Overview.Sensor Input Detail (ZUMNET- and ZUMLINK-JBOX).WebHome]].
38 +Non-system sensors (including Crestron GLS-ODT-C-NS sensors, GLA-LDL photocells, and Steinel occupancy sensors) may be landed at the sensor input terminal block of ZUMNET-JBOX devices. Details on the sensor input wiring can be found [[here>>doc:Wiring Guide.Zūm Wired System Overview.Sensor Input Detail (ZUMNET- and ZUMLINK-JBOX).WebHome]].
39 39  )))
40 40  
41 41  
mg_qs_zumnet-jbox.pdf
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.alexander\.mott@chiefintegrations\.com
Size
... ... @@ -1,0 +1,1 @@
1 +1.7 MB
Content