Skip to Content
Last modified by Alexander Mott on 2024/01/05 18:55
From version 16.1
edited by Alexander Mott
on 2021/12/23 19:51
Change comment: There is no comment for this version
To version 17.1
edited by Alexander Mott
on 2021/12/23 19:52
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -19,7 +19,7 @@
19 19  
20 20  It is important to note that while there are two ZUMLINK ports, Zūm Link runs should never be looped back to a ZUMNET-JBOX. Zūm Link runs should originate at a ZUMNET-JBOX, connect to a number of Zūm Link devices, and then stop at the last Zūm Link device. The reason for having multiple ZUMLINK ports is ease of installation; for example, if there are two ZUMLINK-KP keypads in a room, it might be easier to put them at the end of two separate runs so that only one RJ-45 terminated Zūm Link cable needs to be pulled through conduit.
21 21  
22 -In //[[Figure 1>>xwiki:Wiring Guide.Zūm Wired Systems.Load Controllers (ZUMNET-JBOX).WebHome||anchor="HFigure1"]]//, ZUMLINK ports are shown in orange, ZUMNET ports are shown in purple, and the sensor input block is between them.
22 +In //[[Figure 1>>xwiki:Wiring Guide.Zūm Wired System Overview.Load Controllers (ZUMNET-JBOX).WebHome||anchor="HFigure1"]]//, ZUMLINK ports are shown in orange, ZUMNET ports are shown in purple, and the sensor input block is between them.
23 23  
24 24  == ZUMNET-JBOX-16A-LV Wiring ==
25 25