Zum Wired
Last modified by Craig Lewis on 2024/07/15 20:18
Toolbox Text Console commands for setting up Zum Wired Systems:
| Command | Description |
| autodiscovery query | Will generate a list of all network devices (Must be connected to one of your processors) |
| who | Will generate a list of all online network devices (Must be connected to one of your processors) |
| ZUMNET-JBOX | |
| zwmode | Will tell if your ZUMNET-JBOX is setup for Zum or Cresnet (Newer firmware will also display mode and autoswitch enable/disable) |
| zwmode zum (or cnet) | Will set your Zum Op mode for your ZUMNET-JBOX |
| zwms | Tell which mode the ZUMNET-JBOX is in |
| zwms master (or slave) | Will set mode for ZUMNET-JBOX (old firmware) |
| zwps primary (or secondary) | Will set mode for ZUMNET-JBOX (newer firmware) |
| autoswitch on (or off) | Will enable/disable Autoswitch mode for ZUMNET-JBOX |
| ZUMLINK-OCC-VAC-SENSORS | |
| rcon 1.[CID] detlev [0-15] | Will set Detection Level 0-15 (Sensitivity in the App) |
| rcon 1.[CID] detrang [0-255] | Will set Detection Range 0-255 |
| rcon 1.[CID] setir off (or on) | Will disable/enable IR on ZUMLINK-Occupancy Sensor with IR technology |
| rcon 1.[CID] setus off (or on) | Will disable/enable US on ZUMLINK-Occupancy Sensor with US technology |
| rcon 1.[CID] setto [5-1800] | Will set timeout in seconds for the ZUMLINK-Occupancy Sensor |